CSWA Simulation Questions with
complete solution
h-method of meshing involves - correct answers increasing mesh density
p-method of meshing involves - correct answers increasing mesh element
polynomial order
is it possible to model breaking of glass on the floor using linear static
analysis? - correct answers no
which of the following cases, the rope will most likely break? - correct answers
both are the same
Assuming a linear static study, if the Young's modulus of the material is
doubles (everything else remains the same), then the tensile stress will be -
correct answers doubles
iso lot in the simulation will enable to - correct answers set lower and upper
limits to see desired stress range
which statement best describes a compatible mesh? - correct answers a
mesh where elements on touching bodies have overlaying nodes
maximum and minimum value indicators are displayed on stress and
displacement plots in SOLIDWORKS simulation for a linear static study -
correct answers true
, what SOLIDWORKS simulation tool should you use to determine the result
values at specific locations (nodes) in a model using SOLIDWORKS
simulation? - correct answers probe tool
what criteria are best suited to check the failure of ductile materials in
SOLIDWORKS simulation? - correct answers maximum von Mises stress and
maximum shear stress criterion
what is the modulus of elasticity? - correct answers the slope of the stress-
strain curve in its linear section
what is stress? - correct answers a measure of average amount of force
exerted per unit area
which of the following assumptions are true for a static analysis in
SOLIDWORKS simulation with small displacements? - correct answers 1.
inertia effects are negligible and loads are applied slowly
2. all the displacements are small relative to the model geometry
3. results are proportional to loads
what is yield stress? - correct answers the stress level beyond which the
material becomes plastic
a high-quality shell element has ___ nodes. - correct answers 6
stress is proportional to _________ in linear elastic material. - correct answers
strain
the elastic modulus (Young's modulus) is the slope defined as _______
divided by _______. - correct answers stress, strain
complete solution
h-method of meshing involves - correct answers increasing mesh density
p-method of meshing involves - correct answers increasing mesh element
polynomial order
is it possible to model breaking of glass on the floor using linear static
analysis? - correct answers no
which of the following cases, the rope will most likely break? - correct answers
both are the same
Assuming a linear static study, if the Young's modulus of the material is
doubles (everything else remains the same), then the tensile stress will be -
correct answers doubles
iso lot in the simulation will enable to - correct answers set lower and upper
limits to see desired stress range
which statement best describes a compatible mesh? - correct answers a
mesh where elements on touching bodies have overlaying nodes
maximum and minimum value indicators are displayed on stress and
displacement plots in SOLIDWORKS simulation for a linear static study -
correct answers true
, what SOLIDWORKS simulation tool should you use to determine the result
values at specific locations (nodes) in a model using SOLIDWORKS
simulation? - correct answers probe tool
what criteria are best suited to check the failure of ductile materials in
SOLIDWORKS simulation? - correct answers maximum von Mises stress and
maximum shear stress criterion
what is the modulus of elasticity? - correct answers the slope of the stress-
strain curve in its linear section
what is stress? - correct answers a measure of average amount of force
exerted per unit area
which of the following assumptions are true for a static analysis in
SOLIDWORKS simulation with small displacements? - correct answers 1.
inertia effects are negligible and loads are applied slowly
2. all the displacements are small relative to the model geometry
3. results are proportional to loads
what is yield stress? - correct answers the stress level beyond which the
material becomes plastic
a high-quality shell element has ___ nodes. - correct answers 6
stress is proportional to _________ in linear elastic material. - correct answers
strain
the elastic modulus (Young's modulus) is the slope defined as _______
divided by _______. - correct answers stress, strain
