Automotive Exam Questions and Answers 100% Pass

Automotive Exam Questions and Answers 100% Pass a safety stand is also called a - jack stand a creeper should be stored - vertically the SAE standard for hoist location is - JRP-2184 Tall safety stands would be used to - Help support the vehicle when a major component is removed from the vehicle Commonly damaged areas of a vehicle during hoisting include ______. - All of these Pad extensions may be needed when hoisting what type of vehicle? - Either B or C technician A says that a hoist can be stopped at any level as long as the safety latch engages. Technician B says that the vehicle should be hoisted to the top of the hoist travel for safety. which technician is correct? - Technician A Before lowering the vehicle, what should the technician do? - All of these 2Disclaimer: Original Content, No Copyright Infringement, All Rights Reserved © 2025 Technician A says that a creeper should be stored vertically. Technician B says that a creeper should be stored 9n its casters. Which technician is correct - Technician A only when checking stability, how high should the vehicle be raised - about 1 foot (30cm) most floor jacks have _____ casters - Four Floor jacks are designed to support a load - False Which symbol is used to indicate safe lifting points - Triangle when removing heavy objects that may change the centre of gravity of a vehicle - Both A and B Commonly damaged areas of vehicles being hoisted include - Both A and B Technician A says to never look away from a vehicle being hoisted. Technician B saus that the vehicle must be raised off the mechanical locks before lowering. Which technician is correct? - Both technicians A and B which of these is least likely to be us3d by professional shops - drive-up ramps Technician A Says that drive up ramp may shift and "kick out" allowing the vehicle to drop unexpectedly. Technician B says that the wheels should always be chocked when using ramps. Which technician is correct - Both Technicians A and B 3Disclaimer: Original Content, No Copyright Infringement, All Rights Reserved © 2025 Proper lifting usually requires the vehicle to be ______ - Both A and B Tall pad extensions are used ____ - To engage the frame of trucks The threaded moveable part that rotates on micrometer is called the - Thimble To check a crankshaft journal for Taper, the journal should be measur