Nomad pro 2
Nomad pro 2 exam
Based questions and approved answers
X-ray locks in NOMAD Pro 2 automatically engage after 2 hours of inactivity. -
✔✔✔False
Because NOMAD Pro 2 shielding limits the exposure, it is permissible to have other people
In the exam room during exposures without any precautions. - ✔✔✔False
The NOMAD Pro 2 should be routinely cleaned using disinfectant wipes, or some other
non- acetone cleaner to maintain cleanliness. - ✔✔✔True
The backscatter shield is adjustable to accommodate positioning devices and other special
needs but if the backscatter shield is adjusted, additional precautions are required. -
✔✔✔True
The smaller diameter cone of the NOMAD Pro 2, combined with the use of DC power, and
primary shielding greatly reduce a patient X-ray exposure. - ✔✔✔True
When the NOMAD Pro 2 is powered on and in the settings screen, a single quick pull of the
trigger will enable the device. The green LED will illuminate and the display will indicate
the device is ENABLING X-RAYS and then the ________________ message will appear
on the screen (meaning the next trigger will fire X-rays). - ✔✔✔READY / Green Radiation
Icon
When the NOMAD Pro 2 is not in service, it is advisable to ensure that the device is
securely stored and the X-rays are ______ so that unauthorized / unintended use or damage
does not occur. - ✔✔✔LOCKED
@pg. 1
, Nomad pro 2
An alarm indicating a partial exposure (when the trigger was not depressed through the
entire timer setting, either on purpose or accidentally) is indicated by a series of beeps and
the ____________ message on the screen until a button is pressed. - ✔✔✔INCOMPETE /
RED
Do not ____ the NOMAD Pro 2 until the patient and film/ sensor are positioned and ready
to avoid unintended firing of the NOMAD Pro 2. - ✔✔✔ENABLE / READY
When there is not enough battery charge left to take an exposure, the charge indicator bars
will fade away and the ____ alarm message appears on the screen, and the NOMAD Pro 2
will not allow an exposure to begin. - ✔✔✔RECHARGE HANDSET
If left unused NOMAD Pro 2 will automatically shut down after approximately
______________ minute(s). The NOMAD Pro 2 can also be turned off by pressing the
POWER button. - ✔✔✔3 minutes
Some battery ____ may be lost during extended inactivity (leading to fewer exposures
between each Handset charging session). - ✔✔✔charge
In order to maintain the optimal operator safety zone the backscatter shield should be:
a) held so it is parallel to the oeprator
b) slid back on the cone toward the operator
c) held so NOMAD Pro 2 is positioned close to the patient - ✔✔✔a) Held so it is parallel to
the operator
c) Held so NOMAD Pro 2 is positioned close to the patient.
The duty cycle (or rest period b/w exposures) to protect your NOMAD Pro2 is as follows:
a) 6 sec for an exposure 0.09 sec long
b) 12 sec for an exposure 0.20 sec long
@pg. 2
Nomad pro 2 exam
Based questions and approved answers
X-ray locks in NOMAD Pro 2 automatically engage after 2 hours of inactivity. -
✔✔✔False
Because NOMAD Pro 2 shielding limits the exposure, it is permissible to have other people
In the exam room during exposures without any precautions. - ✔✔✔False
The NOMAD Pro 2 should be routinely cleaned using disinfectant wipes, or some other
non- acetone cleaner to maintain cleanliness. - ✔✔✔True
The backscatter shield is adjustable to accommodate positioning devices and other special
needs but if the backscatter shield is adjusted, additional precautions are required. -
✔✔✔True
The smaller diameter cone of the NOMAD Pro 2, combined with the use of DC power, and
primary shielding greatly reduce a patient X-ray exposure. - ✔✔✔True
When the NOMAD Pro 2 is powered on and in the settings screen, a single quick pull of the
trigger will enable the device. The green LED will illuminate and the display will indicate
the device is ENABLING X-RAYS and then the ________________ message will appear
on the screen (meaning the next trigger will fire X-rays). - ✔✔✔READY / Green Radiation
Icon
When the NOMAD Pro 2 is not in service, it is advisable to ensure that the device is
securely stored and the X-rays are ______ so that unauthorized / unintended use or damage
does not occur. - ✔✔✔LOCKED
@pg. 1
, Nomad pro 2
An alarm indicating a partial exposure (when the trigger was not depressed through the
entire timer setting, either on purpose or accidentally) is indicated by a series of beeps and
the ____________ message on the screen until a button is pressed. - ✔✔✔INCOMPETE /
RED
Do not ____ the NOMAD Pro 2 until the patient and film/ sensor are positioned and ready
to avoid unintended firing of the NOMAD Pro 2. - ✔✔✔ENABLE / READY
When there is not enough battery charge left to take an exposure, the charge indicator bars
will fade away and the ____ alarm message appears on the screen, and the NOMAD Pro 2
will not allow an exposure to begin. - ✔✔✔RECHARGE HANDSET
If left unused NOMAD Pro 2 will automatically shut down after approximately
______________ minute(s). The NOMAD Pro 2 can also be turned off by pressing the
POWER button. - ✔✔✔3 minutes
Some battery ____ may be lost during extended inactivity (leading to fewer exposures
between each Handset charging session). - ✔✔✔charge
In order to maintain the optimal operator safety zone the backscatter shield should be:
a) held so it is parallel to the oeprator
b) slid back on the cone toward the operator
c) held so NOMAD Pro 2 is positioned close to the patient - ✔✔✔a) Held so it is parallel to
the operator
c) Held so NOMAD Pro 2 is positioned close to the patient.
The duty cycle (or rest period b/w exposures) to protect your NOMAD Pro2 is as follows:
a) 6 sec for an exposure 0.09 sec long
b) 12 sec for an exposure 0.20 sec long
@pg. 2
