NX DESIGN ASSOCIATE
CERTIFICATION EXAM | 146
QUESTIONS | WITH ACTUAL
SOLUTIONS!!
1 of 146
Term
If you need to make a duplicate solid body to modify, what
command would you use?
Give this one a try later!
Make symmetric Mirror part
Delete face Extract Geometry - Body
, Don't know?
2 of 146
Term
When creating an offset curve, how do you switch from
sharp corners to a radius corner based off the offset
value?
Give this one a try later!
Increase the Offset
Apply a Texture to the Curve Value to Maximum
Switch Change the Cap Option to Arc
to a Different Drawing Tool
Cap
Don't know?
3 of 146
Term
Can design intent be incorporated after the initial model
construction?
Give this one a try later!
, Yes, but may be more difficult Extract Geometry - Mirror Body
Expressions that are not used Synchronous Modeling Commands
Don't know?
4 of 146
Term
What command allows you to create a feature by
rotating a section string around an axis through a
specified angle?
Give this one a try later!
revolve draft
sweep extrude
Don't know?
5 of 146
Term
When creating an extrude, what curve rule will ensure
that you select all of the sketch curves?
, Give this one a try later!
Tangent Curves Feature Curves
Connected Curves Region Boundary Curves
Don't know?
6 of 146
Term
What type of expressions cannot be deleted?
Give this one a try later!
The Add Component Dialog Sketch Curves
System Expressions Unused Expressions
Don't know?
CERTIFICATION EXAM | 146
QUESTIONS | WITH ACTUAL
SOLUTIONS!!
1 of 146
Term
If you need to make a duplicate solid body to modify, what
command would you use?
Give this one a try later!
Make symmetric Mirror part
Delete face Extract Geometry - Body
, Don't know?
2 of 146
Term
When creating an offset curve, how do you switch from
sharp corners to a radius corner based off the offset
value?
Give this one a try later!
Increase the Offset
Apply a Texture to the Curve Value to Maximum
Switch Change the Cap Option to Arc
to a Different Drawing Tool
Cap
Don't know?
3 of 146
Term
Can design intent be incorporated after the initial model
construction?
Give this one a try later!
, Yes, but may be more difficult Extract Geometry - Mirror Body
Expressions that are not used Synchronous Modeling Commands
Don't know?
4 of 146
Term
What command allows you to create a feature by
rotating a section string around an axis through a
specified angle?
Give this one a try later!
revolve draft
sweep extrude
Don't know?
5 of 146
Term
When creating an extrude, what curve rule will ensure
that you select all of the sketch curves?
, Give this one a try later!
Tangent Curves Feature Curves
Connected Curves Region Boundary Curves
Don't know?
6 of 146
Term
What type of expressions cannot be deleted?
Give this one a try later!
The Add Component Dialog Sketch Curves
System Expressions Unused Expressions
Don't know?
