Welding Level 2 Module 7 Exam
Questions and Answers 100% Solved
When a cable tray section branches off from a main section in two
90° turns, the section is called a(n) __________. - ✔✔Tee
A section of cable tray that makes a single horizontal 90° turn is
known as a(n) __________. - ✔✔Elbow
Which of the following best describes the type of fitting that will be
used with a solid cover cable tray? - ✔✔A Cover Clamp
A(n) __________ branches in four different directions. -
✔✔Horizontal Cross
Which of the following best describes how closely packed cables
will be affected when energized? - ✔✔Their efficiency will be
decreased
1
©NINJANERD 2024/2025. YEAR PUBLISHED 2024.
, When a cable tray system must be protected from dropping
objects that may damage the cable, a __________ is used. -
✔✔Tray Cover
When cable exits downward from a tray without a dropout plate,
__________ could occur. - ✔✔Insulation Damage
The main purpose of vertical adjustment splice plates is to
__________. - ✔✔Change the elevation in a run of cable tray
A barrier strip is a __________. - ✔✔Division strip installed in a
raceway to separate certain types of cables
Which of the following is a violation of NEC Section 300.8? -
✔✔Placing an instrumentation air line in the same tray with
electrical conductors
Except for Type MC, all multiconductor cables over 600V must be
separated by a solid divider from cables rated under _____. -
✔✔600V
2
©NINJANERD 2024/2025. YEAR PUBLISHED 2024.
Questions and Answers 100% Solved
When a cable tray section branches off from a main section in two
90° turns, the section is called a(n) __________. - ✔✔Tee
A section of cable tray that makes a single horizontal 90° turn is
known as a(n) __________. - ✔✔Elbow
Which of the following best describes the type of fitting that will be
used with a solid cover cable tray? - ✔✔A Cover Clamp
A(n) __________ branches in four different directions. -
✔✔Horizontal Cross
Which of the following best describes how closely packed cables
will be affected when energized? - ✔✔Their efficiency will be
decreased
1
©NINJANERD 2024/2025. YEAR PUBLISHED 2024.
, When a cable tray system must be protected from dropping
objects that may damage the cable, a __________ is used. -
✔✔Tray Cover
When cable exits downward from a tray without a dropout plate,
__________ could occur. - ✔✔Insulation Damage
The main purpose of vertical adjustment splice plates is to
__________. - ✔✔Change the elevation in a run of cable tray
A barrier strip is a __________. - ✔✔Division strip installed in a
raceway to separate certain types of cables
Which of the following is a violation of NEC Section 300.8? -
✔✔Placing an instrumentation air line in the same tray with
electrical conductors
Except for Type MC, all multiconductor cables over 600V must be
separated by a solid divider from cables rated under _____. -
✔✔600V
2
©NINJANERD 2024/2025. YEAR PUBLISHED 2024.
