CWB 47.1 CORRECT QUESTIONS & ANSWERS(RATED A)

CWB 47.1 CORRECT QUESTIONS &
ANSWERS(RATED A)
CSA Standard W47.1 provides the requirements that must be met and adhered to by
a company seeking certification.
True or False? - ANSWERTrue

Certification can be considered as an approval of the products fabricated by a
certificated company?
True or false?! - ANSWERFalse

What does "class" refer to?
A) "T", "S", "FW", "ASW" or "WT" designation of welding personnel.
B) Electrode groups
C) a category of welder qualification, e.g., F, H,V or O welding position
D) Fillet and groove we'd combined test plate assemblies - ANSWERC

What does classification refer to?
A) "T", "S", "FW", "ASW" or "WT" designation of welding personnel.
B) Electrode groups
C) a category of welder qualification, e.g., F, H,V or O welding position
D) Fillet and groove we'd combined test plate assemblies - ANSWERA

What organization administer CSA Standard W47.1
A) there is no administrator
B) Canadian standards association
C) Canadian welding bureau - ANSWERC

The Canadian welding bureau can withdraw a company's certification if the company
is NOT following the requirements of CSA standard W47.1
True or false ? - ANSWERTrue

How many divisions of certification are specified in CSA Standard W47.1 ?
A) one
B) two
C) three
D) four - ANSWERC

Is a company certified in division 1 required to employ a full time or retain a part time
welding engineer?
A) retain a part time welding engineer
B) employ a full time welding engineer
C) no engineer is required
D) employ a full time welding inspector only - ANSWERB

Is a company certified in division 3 required to employ a full time or retain a part time
welding engineer?

, A) Employ a full time welding engineer
B) Retain a part time welding engineer
C) retain a part time welding engineer responsible to the company only for welding
procedures and practice
D) No welding engineer is required - ANSWERD

CSA Standard W47.1 requires each designated plant, shop or section to meet the
requirements of certification within this standard with respect to welders, welding
procedures specification, welding procedure data sheets, welding supervisor and
welding engineer, where applicable
True or false? - ANSWERTrue

A company doing only erection work involving welding must have a pony in order to
be certified to CSA standard W47.1
True or false? - ANSWERFalse

When must the company inform the Canadian bureau of any loss or change in
welding engineering or supervisory personnel?
A) immediately
B) after 3 months
C) after 6 months
D) the doesn't have to inform as long as the personnel is replaced after a year -
ANSWERA

The company shall designate an individual who, irrespective of each other
responsibilities, shall have defined authority and responsibility for ensuring that the
requirements of CSA Standard W47.1 are implemented and maintained
True or false? - ANSWERTrue

What are the duties of the welding engineer?
A) Provide engineering support to the company as required.
B) Development of new welding procedures
C) Periodic reviews of the company's welding practices
D) preparation of WPSs and WPDSs
E) all of the above - ANSWERE

Who owns the welder cards that are issued by the Canadian welding bureau?
A) the company
B) the welder
C) the Canadian welding bureau
D) the welding supervisor - ANSWERC

Who is responsible for ensuring that welders identification cards or copies thereof
can be produced as proof that a welder has valid qualification?
A) the welder
B) the Canadian welding bureau
C) the company
D) the welding supervisor - ANSWERC