Costco ILE 3 Exam Questions And Correct Answers
100% Verified Latest Update
when a patient can hear voices further away rather than close what should the hearing
healthcare provider consider adjusting?
A. increase loud sounds so that compression decreases.
B. increase soft sounds so that compression increases
C. increase all gain input levels so sounds are louder and compression ratio remain the
same
D. decrease loud sounds so that compression increases - ANSWER A
which method of evaluation allows a hearing healthcare provider to make sure a hearing
aid is meeting manufacturer's specifications?
a. REM
b. listening check
c. patient self-report
d. test box - ANSWER d
why are vents used in ear molds and custom Hearing Instruments?
a. To amplify low frequencies
B. To attenuate high frequencies
C. To attenuate low frequencies
D. To amplify high frequencies - ANSWER C
the patient reports that their 2-week follow-up that the sounds like utensils, paper, Etc
, are too sharp and loud. What should be adjusted to help with this issue?
a. decrease mid frequencies
b. decrease low frequencies
c. decrease high frequencies
d. decrease all frequencies - ANSWER c
the 2003 NSI standards require that equivalent input noise test be run at what level?
a. 30 dB
b. 50 dB
c. FOG
d. 60 dB - ANSWER b
when would the output of hearing aid need to be limited?
a. the hearing loss increases
b. the ucl's decrease
c. the dynamic range increases
d. all of the above - ANSWER b
an ear mold has no vent and a snap ring. What type of hearing instrument should be
used with this ear mold?
a. BTE with # 15 tubing
b. BTE with thin tube
c. BTE with damper ear hook
100% Verified Latest Update
when a patient can hear voices further away rather than close what should the hearing
healthcare provider consider adjusting?
A. increase loud sounds so that compression decreases.
B. increase soft sounds so that compression increases
C. increase all gain input levels so sounds are louder and compression ratio remain the
same
D. decrease loud sounds so that compression increases - ANSWER A
which method of evaluation allows a hearing healthcare provider to make sure a hearing
aid is meeting manufacturer's specifications?
a. REM
b. listening check
c. patient self-report
d. test box - ANSWER d
why are vents used in ear molds and custom Hearing Instruments?
a. To amplify low frequencies
B. To attenuate high frequencies
C. To attenuate low frequencies
D. To amplify high frequencies - ANSWER C
the patient reports that their 2-week follow-up that the sounds like utensils, paper, Etc
, are too sharp and loud. What should be adjusted to help with this issue?
a. decrease mid frequencies
b. decrease low frequencies
c. decrease high frequencies
d. decrease all frequencies - ANSWER c
the 2003 NSI standards require that equivalent input noise test be run at what level?
a. 30 dB
b. 50 dB
c. FOG
d. 60 dB - ANSWER b
when would the output of hearing aid need to be limited?
a. the hearing loss increases
b. the ucl's decrease
c. the dynamic range increases
d. all of the above - ANSWER b
an ear mold has no vent and a snap ring. What type of hearing instrument should be
used with this ear mold?
a. BTE with # 15 tubing
b. BTE with thin tube
c. BTE with damper ear hook
