NEW 2024 ASE AUTOMATIC
TRANSMISSIONS STUDY SET WITH
ACCURATE ANSWERS
, NEW 2024 ASE AUTOMATIC
TRANSMISSIONS STUDY SET WITH
ACCURATE ANSWERS
After a long drive red fluid is seen on the transmission case and under the chassis of a vehicle. 42. Which
type of automatic transmission bearing requires a preload?
A. Ball Bearing
B. Thrust
C. Tapered Roller
D. Needle - CORRECT ANSWERSC. Tapered Roller
The extension housing seal is leaking and the bushing is worn on one side. Technician A says this could
be caused by a binding universal joint. Technician B says this is likely caused by excessive output shaft
endplay. Who is correct?
A Technician A
B. Technician B
C. Both A and B
D. Neither A or B - CORRECT ANSWERSA. Technician A
Technician A says this can be caused by fluid aeration. Technician B says this could be caused by engine
overheating. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - CORRECT ANSWERSC. Both A and B
The MIL is illuminated and the transmission only operates in third and reverse gears. Which of the
following is the MOST likely cause of this condition?
TRANSMISSIONS STUDY SET WITH
ACCURATE ANSWERS
, NEW 2024 ASE AUTOMATIC
TRANSMISSIONS STUDY SET WITH
ACCURATE ANSWERS
After a long drive red fluid is seen on the transmission case and under the chassis of a vehicle. 42. Which
type of automatic transmission bearing requires a preload?
A. Ball Bearing
B. Thrust
C. Tapered Roller
D. Needle - CORRECT ANSWERSC. Tapered Roller
The extension housing seal is leaking and the bushing is worn on one side. Technician A says this could
be caused by a binding universal joint. Technician B says this is likely caused by excessive output shaft
endplay. Who is correct?
A Technician A
B. Technician B
C. Both A and B
D. Neither A or B - CORRECT ANSWERSA. Technician A
Technician A says this can be caused by fluid aeration. Technician B says this could be caused by engine
overheating. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - CORRECT ANSWERSC. Both A and B
The MIL is illuminated and the transmission only operates in third and reverse gears. Which of the
following is the MOST likely cause of this condition?