SENSE LEVEL 1: Mod 3 Drawing and
Welding Symbol Interpretation
1. Information appearing above the reference line refers to the _____. - ✔️✔️other side
2. The graphic representation of a weld to be preformed is called a _____. - ✔️✔️Weld
Symbol
3. The Welding symbol shown in Figure 4 depicts a ______ - ✔️✔️Single V-groove
weld on the arrow-side with melt through
4. Which of the following is NOT considered a type of weld joint? - ✔️✔️Fillet
5. The weld joint formed when two parallel members overlap each other is called a
_______ joint. - ✔️✔️Lap
6. In a single V-groove, the sloped surfaces on which the weld metal is applied are
called - ✔️✔️Groove Faces
7. A weld applied to the other side of a joint before the groove weld is started is called a
______. - ✔️✔️Backing Weld
8. The finished surface (cover pass) of a weld is referred to as the______. - ✔️✔️Weld
Face
9. In a completed weld, the junction between the surface of a weld and the base metal
is called the _______. - ✔️✔️Toe
10. The height of the weld above the base metal in a groove weld is called the _____. -
✔️✔️Weld Reinforcement
11. The primary element of any welding symbol is referred to as the______. -
✔️✔️Reference Line
12. Information appearing below the reference line refers to the_____. - ✔️✔️Arrow
Side
Welding Symbol Interpretation
1. Information appearing above the reference line refers to the _____. - ✔️✔️other side
2. The graphic representation of a weld to be preformed is called a _____. - ✔️✔️Weld
Symbol
3. The Welding symbol shown in Figure 4 depicts a ______ - ✔️✔️Single V-groove
weld on the arrow-side with melt through
4. Which of the following is NOT considered a type of weld joint? - ✔️✔️Fillet
5. The weld joint formed when two parallel members overlap each other is called a
_______ joint. - ✔️✔️Lap
6. In a single V-groove, the sloped surfaces on which the weld metal is applied are
called - ✔️✔️Groove Faces
7. A weld applied to the other side of a joint before the groove weld is started is called a
______. - ✔️✔️Backing Weld
8. The finished surface (cover pass) of a weld is referred to as the______. - ✔️✔️Weld
Face
9. In a completed weld, the junction between the surface of a weld and the base metal
is called the _______. - ✔️✔️Toe
10. The height of the weld above the base metal in a groove weld is called the _____. -
✔️✔️Weld Reinforcement
11. The primary element of any welding symbol is referred to as the______. -
✔️✔️Reference Line
12. Information appearing below the reference line refers to the_____. - ✔️✔️Arrow
Side
