Journeyman Plumbing Codes -KY Questions
With Solutions 100% Solved
What does ASTM stand for? American Society for Testing and Materials
Joints and connections shall be made _____ and _______ tight. Gas and Water
Caulked joints shall be firmly packed with _______ or _______ and shall have at least ________
pure lead properly caulked. Oakum or hemp— 1"
Polyvynil chloride schedule 40 or 80 pipe and fittings shall be ________ _________ joints?
Solvent welded
Where can you install a slip joint on the outside of a trap? Outlet side with 1-1/2"
elastomeric gasket
Flashings should extend _______ in all directions. 6 inches
Three and four inch lead flashings shall have a minimum _______ inch base. 12
, Journeyman Plumbing Codes -KY Questions
With Solutions 100% Solved
A tubular brass trap shall be ______ gauge. 17
Traps shall have a water seal not less than ____ inches and not more than _____ inches. 2
and 4
If a stack is over _____ feet tall, a _______ ______ shall be provided. 45 —- clean out
There shall be at least _____ clean out in a building drain with a ______-_______ branch inside
the wall or outside the building at a point not to exceed ____ feet from the foundation wall.
1— full size— 2
All clean outs shall be __________ fittings. 2-directional
A clean out shall be the same nominal size as the pipe it serves up to ____ inch and shall not be
less than ____ inch for pipes any larger. 4-4
A clean out installed on a ___ inch sewer shall be ____ directional. 4- 2
With Solutions 100% Solved
What does ASTM stand for? American Society for Testing and Materials
Joints and connections shall be made _____ and _______ tight. Gas and Water
Caulked joints shall be firmly packed with _______ or _______ and shall have at least ________
pure lead properly caulked. Oakum or hemp— 1"
Polyvynil chloride schedule 40 or 80 pipe and fittings shall be ________ _________ joints?
Solvent welded
Where can you install a slip joint on the outside of a trap? Outlet side with 1-1/2"
elastomeric gasket
Flashings should extend _______ in all directions. 6 inches
Three and four inch lead flashings shall have a minimum _______ inch base. 12
, Journeyman Plumbing Codes -KY Questions
With Solutions 100% Solved
A tubular brass trap shall be ______ gauge. 17
Traps shall have a water seal not less than ____ inches and not more than _____ inches. 2
and 4
If a stack is over _____ feet tall, a _______ ______ shall be provided. 45 —- clean out
There shall be at least _____ clean out in a building drain with a ______-_______ branch inside
the wall or outside the building at a point not to exceed ____ feet from the foundation wall.
1— full size— 2
All clean outs shall be __________ fittings. 2-directional
A clean out shall be the same nominal size as the pipe it serves up to ____ inch and shall not be
less than ____ inch for pipes any larger. 4-4
A clean out installed on a ___ inch sewer shall be ____ directional. 4- 2
