Intelitek blueprints post test Questions and Correct Answers | Latest Update

Projection lines Shows relationships between lines Object lines Thick lines Center lines Long thin lines with short dashes between the segments Extension lines Narrow lines Break line The object is not fully represented in the blueprint Phantom line Master01 | October, 2024/2025 | Latest update 1 | P a g e | © copyright 2024/2025 | Grade A+ A line that shows an object in more than one position Top view and right side view Views that depict a shaft shown horizontally Top view, front view and right side view Common views depicting a three view blueprint Top view, front view Views that depict a shaft shown vertically Auxiliary view(s). Slanted surfaces require showing this 10:1 This represents on a blueprint a small object is shown ten times larger than it actually is. 10:10 Master01 | October, 2024/2025 | Latest update 1 | P a g e | © copyright 2024/2025 | Grade A+ This represents on a blueprint the object is shown to scale. 1:10 This represents on a blueprint one inch is equal to ten. 1.197 inches. A shaft diameter dimensioned as 1.200 inches (+/- 0.003 inches) means that the smallest diameter permitted for the shaft is Shaft 2 is 12.01cm We need a shaft that is 12 cm (-0.2/+0.5) long. Which of the following shafts must we select? 25.48 degree