Fire Pump Test Questions and Answers

Fire Pump Test Questions and Answers Heat exchangers shall be checked for _____ water flow. - Answer️️ - cooling All alarm pilot lights should be in what state? - Answer️️ -Off There are two requirements listed under pump house conditions, choose both listed below. - Answer️️ -Ventilating louvers are free to operate & Heat is adequate, not less than 40F for diesel pump rooms. Weekly inspection requires verification that pump suction discharge and bypass valves should be fully open? - Answer️️ -True When verifying the electrical system conditions, the controller pilot light should be? - Answer️️ -Green Diesel engine fuel tank level, float switch and solenoid valve operation shall be checked _____. - Answer️️ -weekly What fire pump type do you record the time to crank? - Answer️️ -Diesel The pertinent visual observation categories required to be inspected weekly checklist are? - Answer️️ -Pump house conditions, Pump system conditions, electrical system conditions, diesel engine system conditions, steam system conditions. The purpose of inspecting the pump assembly? - Answer️️ -Appears to be in operating condition and is free from physical damage ©SOPHIABENNETT@ Saturday, August 24, 2024 8:52 AM 2 The transfer switch normal pilot light should be illuminated. - Answer️️ - True The isolating switch for electric pumps should be closed. - Answer️️ -True Pump packing boxes, bearings and casing shall be checked for _____. - Answer️️ -overheating The reverse phase alarm pilot light for electric pumps should be off. - Answer️️ -True The purpose of testing the pump assembly is to ensure automatic and manual operation upon demand and continuous delivery of the required system output. An additional purpose is to detect _____. - Answer️️ - deficiencies not evident by inspection The normal phase rotation pilot light should be on. - Answer️️ -True At what level should the oil level in the vertical motor sight glass be? - Answer️️ -Normal When verifying water level in suction reservoir during weekly inspection, the water level should be full. - Answer️️ -True Controllers include air, _____, or electrical operated units. - Answer️️ - hydraulic At what level should the fuel tank be? - Answer️️ -2/3 ©SOPHIABENNETT@ Saturday, August 24, 2024 8:52 AM 3 The weekly test pertinent adjustments shall be made while the pump is _____. - Answer️️ -running The controller selector switch should be in the _____ position. - Answer️️ -auto The number of engine operating hours is measured by the _____? - Answer️️ -engine running time meter The oil level in the right angle gear drive should be normal. - Answer️️ - True Types of centrifugal fire pumps include single and multistage units of horizontal and vertical shaft design. - Answer️️ -True For both Electric & Diesel pumps, the wet pit suction