00104 NCCER ASSESSMENT TEST
QUESTIONS WITH CORRECT ANSWERS
Trigger lock - Answer-When using power tools t=you never engage the
______________
disconnect the power source - Answer-before replacing things like bits, blades, discs or
any tool you must
drill bit - Answer-most hammer drills will not hammer unless pressure is applied to the
________
a power source is unavailable - Answer-a pnuematic drill is commonly used when
_______________
the guard protects you from touching the blade - Answer-never use a circular saw that
dosen;t have an upper blade guard because _______________.
kerf - Answer-when using a curcular saw be sure to cut on the waist side of the cut mark
to allow for the blade's ____
saber saws - Answer-saw with fine blades that are excellent for intricate cutting are
called __________.
the power switch is in the off position - Answer-before you plug any saw into a power
source make sure __________________
band saw - Answer-a saw that has a thin one piece blade that runs around a guide is
called ___________________.
a circular saw - Answer-a power miter saw combines a miter box with _____________
hard and heavy materials - Answer-an angle grinder is used to grind
1/8 of an inch - Answer-that adjustable tool rest on a bench grinder should be positioned
____________ on the grinding wheel
a ring test - Answer-a good way to check the condition of a grinding wheel on a bench
grinder is to perform ____________________.
burr bits - Answer-a grinder can catch on rough material edges and shift around
especially when you are using rotary bits called
a powder actuated tool - Answer-a low velocity fastening system that is used to drive
steel pins or threaded studs into masenary and steel is ________________
QUESTIONS WITH CORRECT ANSWERS
Trigger lock - Answer-When using power tools t=you never engage the
______________
disconnect the power source - Answer-before replacing things like bits, blades, discs or
any tool you must
drill bit - Answer-most hammer drills will not hammer unless pressure is applied to the
________
a power source is unavailable - Answer-a pnuematic drill is commonly used when
_______________
the guard protects you from touching the blade - Answer-never use a circular saw that
dosen;t have an upper blade guard because _______________.
kerf - Answer-when using a curcular saw be sure to cut on the waist side of the cut mark
to allow for the blade's ____
saber saws - Answer-saw with fine blades that are excellent for intricate cutting are
called __________.
the power switch is in the off position - Answer-before you plug any saw into a power
source make sure __________________
band saw - Answer-a saw that has a thin one piece blade that runs around a guide is
called ___________________.
a circular saw - Answer-a power miter saw combines a miter box with _____________
hard and heavy materials - Answer-an angle grinder is used to grind
1/8 of an inch - Answer-that adjustable tool rest on a bench grinder should be positioned
____________ on the grinding wheel
a ring test - Answer-a good way to check the condition of a grinding wheel on a bench
grinder is to perform ____________________.
burr bits - Answer-a grinder can catch on rough material edges and shift around
especially when you are using rotary bits called
a powder actuated tool - Answer-a low velocity fastening system that is used to drive
steel pins or threaded studs into masenary and steel is ________________
