ASE Auto Maintenance & Light Repair Test
(Test G1) Practice Questions and Answers
A tight timing belt makes what type of noise? - Answer✔️✔️-Whining
A RWD (rear wheel drive) transmission has a leaking output shaft
seal on a vehicle with 25,000 miles on the odometer. The MOST
likely cause for the leakage is: - Answer✔️✔️-plugged transmission
breather filter
Of the following, when replacing a CV (constant velocity) joint or
boot, what is the last step before clamping the boot? - Answer✔️✔️-
Burping
Steering dampers can be used to reduce excessive __________. -
Answer✔️✔️-positive caster
A technician is rotating the tires using the modified X-method of
tire rotation on a front-wheel-drive vehicle. Where should be the
right front wheel placed? - Answer✔️✔️-Right rear
The open circuit voltage (OCV) test on a fully charged battery
should show which voltage? - Answer✔️✔️-12.6
There is white exhaust smoke coming from the tailpipe of a vehicle
well after the engine has been started. What is causing this
condition? - Answer✔️✔️-coolant in combustion chamber
1
, ©SOPHIABENNET@2024/2025 Wednesday, August 21, 2024 12:13 PM
A front wheel drive vehicle has a clacking noise that only occurs
while cornering. The technician suspects a faulty front axle. Which
of these is most likely the cause? - Answer✔️✔️-outer CV Joint
The tread of a tire is worn in the center and not on the outer
shoulders. Technician A says this is caused by an improper wheel
alignment angle. Technician B says this is caused by an over-
inflated tire. Who is correct? (Just the letter) - Answer✔️✔️-B
A vehicle with power assist brakes has a hard brake pedal. Which of
these is the most likely cause? - Answer✔️✔️-faulty brake booster
Technician A says that oil should be squirted into all of the
cylinders before taking a compression test. Technician B says that if
the compression greatly increases when some oil is squirted into
the cylinders, it indicates defective or worn piston rings. Which
technician is correct? (Letter only) - Answer✔️✔️-B
During a cylinder leakage (leak-down) test, air is noticed coming out
of the oil fill opening. Technician A says that the oil filter may be
clogged. Technician B says that the piston rings may be worn or
defective. Which technician is correct? (Letter only) - Answer✔️✔️-B
What precautions are needed to be performed to help prevent air
from getting trapped in the cooling system when replacing coolant?
- Answer✔️✔️-Open the bleeder valve during filling
To flush a hydraulic clutch system, what should be used? -
Answer✔️✔️-DOT 3
2