ASE COLLISION REPAIR AND REFINISH
TESTS QUESTIONS AND ANSWERS
WITH SOLUTIONS 2024
Painter A says that metal conditioner should be used under plastic filler to assure proper adhesion.
Painter B says that metal conditioner should be used under plastic filler only if rust is present.
Who is right?
(A) A only (C) Both A and B (B) B only (D) Neither A nor B - ANSWER * (D) Neither A nor B
Painter A says that primer-surfacer will dry faster if it is sprayed in several coats with flash time between
coats.
Painter B says that there will be less bridging if all the primer-surfacer is sprayed in one application.
Who is right?
(A) A only (C) Both A and B (B) B only (D) Neither A nor B - ANSWER * (A) A only
Before applying paint, a painter should select the fluid nozzle and needle based on the:
(A) size of the job. (C) spray booth manufacturer. (B) type of coating. (D) painter preference. - ANSWER *
(B) type of coating
Which of these could cause swirl marks when machine polishing or glazing a clear coat?
(A) Moving the polisher too slowly
(B) Using a low-speed polisher
(C) Using a pad that is too coarse
(D) Applying the polishing compound too thickly - ANSWER * (C) Using a pad that is too coarse
To remove orange peel from a painted surface, the painter should wet sand with:
(A) # 1200 and compound.
TESTS QUESTIONS AND ANSWERS
WITH SOLUTIONS 2024
Painter A says that metal conditioner should be used under plastic filler to assure proper adhesion.
Painter B says that metal conditioner should be used under plastic filler only if rust is present.
Who is right?
(A) A only (C) Both A and B (B) B only (D) Neither A nor B - ANSWER * (D) Neither A nor B
Painter A says that primer-surfacer will dry faster if it is sprayed in several coats with flash time between
coats.
Painter B says that there will be less bridging if all the primer-surfacer is sprayed in one application.
Who is right?
(A) A only (C) Both A and B (B) B only (D) Neither A nor B - ANSWER * (A) A only
Before applying paint, a painter should select the fluid nozzle and needle based on the:
(A) size of the job. (C) spray booth manufacturer. (B) type of coating. (D) painter preference. - ANSWER *
(B) type of coating
Which of these could cause swirl marks when machine polishing or glazing a clear coat?
(A) Moving the polisher too slowly
(B) Using a low-speed polisher
(C) Using a pad that is too coarse
(D) Applying the polishing compound too thickly - ANSWER * (C) Using a pad that is too coarse
To remove orange peel from a painted surface, the painter should wet sand with:
(A) # 1200 and compound.
