SkyWest ERJ tasks and flows Questions with correct answers

SkyWest ERJ tasks and flows Questions with correct answers Originating Flow- After safety and power up checklist Baro set to inches HSI set BRG set Glareshield lights adjusted ADS Probe heaters on if icing conditions Reversionary panel dark/ auto PFD no flags MFD reverse "C" Audio panel mic, spkr, volume O2 test Alternate gear extension switch normal lever down What you need for "To the line" Release Atis PDC Fuel Before start to the line task- As passengers are boarding PF: Set up MCDU- Transponder, Route, PERF INIT, Stop at ZFW PM: ACARS, Verify route and PERF INIT PF: CASH (Course, Altitude set, Source to PF side, Heading Indicator to rwy heading) PM: Verify CASH set correctly PF: Takeoff WANT briefing PF: Set RTO Before start to the line flow- As passengers are boarding *Items accomplished on a quick turn, no originating flow was done *O2 Test *PFD no flags *MFD reverse "C" Below the Line Tasks FO- Done after FA brings PIN and ramper brings CLR Complete ACARS Read Takeoff data to Captain Set pitch for takeoff verify departure limit speeds and altitudes Below the Line Tasks Captain Done after FA brings PIN and ramper brings CLR Check ACARS ZFW Enter ZFW Takeoff data Enter V-Speeds Set Vfs on airspeed tape Press TOGA view crossbars on PFD Before start "below the line" Flow- After FA gives the thumbs up ready to go Seat Belt Shoulder Harness secure Beacon on Hydraulic Pump 3A on Window closed Doors shut on status page Cockpit Doors lock button dark Transponder On Engine 1 Start CA: "Start Engine 1" FO: "Starting Engine 1(2)" Selector to Start Start timer FP: "Normal Start" After Start Checklist CA Calls "Flaps 2 APU Off, Flight Control Check" MFD to status Set flaps to 2 APU off ADS Probe Heater off (if you turned it on) Watch captain do the flight control check Taxi Clearance CA: "Clear left" FO: "Clear right" Turn taxi light on Engine 2 Start: No less than 2 min before takeoff CA: "Crossbleed Start Engine 2" FO: "Starting Engine 2" Increase left throttle to 40% Check status page for 40-45 PSI Selector to Start Start timer After start return throttle to idle FO "Normal Start" Before Takeoff to the Line Task- Captain calls for Before Takeoff to the Line Checklist Announce takeoff to passengers ask FA to secure the cabin Call FA to ensure cabin is secure Takeoff data FMS Nav-RWY, FPL Check Brake temps, then change to map page Press Takeoff config button verify RWY Cleared for LUW or Takeoff All lights on Read checklist CA: "Heading Checked" FO: "Checked" CA press A/T Takeoff Actions and Call Outs PF: "Check thrust" PM: "Thrust checked" PM: "80 Knots" PF: "Checked" PM: "V1" PM: "Rotate" PM: "Positive rate" PF: "Gear up" PM: "Gear up" PF: 400ft "Hdg" or "Nav" PM: Selects "Hdg" or "Nav" PF: 1000ft "Climb sequence" PM: Selects VNAV, FMS speed PM: "Flaps up" PF: "After takeoff checklist" PM: "After takeoff checklist complete" Climb Callouts PF: "Ten Thousand" PM: All lights below taxi off, Sterile light off PF/PM: FL180 Push altimeters to STD Reaching Cruise Altitude Monitor Fuel Trend Prior to Descent Tasks PF (preformed before descent flow and checklist) 1) Approach set up: MCDU/Freq/Baro Min/PREV/App speeds 2) Arrival WANT briefing 3) Set autobrake Call for "Descent Checklist" FLOW: Belts Baro Brakes