OSHA-10 Final Exam Questions with 100% Correct Answers

10. Employees must not work on scaffold surfaces until: - It is determined to have strength and structural integrity to support intended loads 11. From your choices below, what would you consider to be a "major" fall hazard in construction? - A. Roof edges and floor openings B. Steel erection C. Improper scaffold construction D. Unsafe use of portable ladders E. All the above 12. Climbing on the cross braces of scaffolds is allowed: - Never 13. If there are defects found during the inspection of personal fall protection equipment, or if the equipment has been used in an arrest, it must be: - Removed immediately from service 14. More than 33% of fatalities in construction are from a combination of falls from: - Roofs 15. Examples of fall hazards that have resulted in deaths on the jobsite include: - A. Falls to the ground or lower levels B. Falls through existing floor or roof openings C. Falls through the floor or roof surface D. Falls on the same level E. All the above 16. How can YOU prevent a fall from a ladder? - A. Choose the right ladder for the job B. Tie the top and bottom of the ladder to fixed points when necessary C. Don't carry tools or other materials in-hand while climbing the ladder D. All the above17. Three major components of a Personal Fall Arrest System (PFAS) include; anchor and the anchorage connector; full body harness; and: - Connecting device (lanyard with shock absorber/retractable lifeline, snap hooks) 18. When using scaffolds, make sure there is which of the following? - A. Safe and compliant access and egress B. Full planking C. Stable footing D. Guard railing E. All of the above 19. Preventing fall hazards is a critical part of the construction planning process. Controls to mitigate fall hazards include installing which of the following? - A. Guardrails B. Walls C. Protective covers D. Parapets E. All of the above 20. OSHA requires fall protection at different heights for construction and general industry however, regardless of the fall distance, which of the following is most correct? - A. Fall protection must be provided when working over dangerous equipment B. Fall protection must be provided when working over dangerous machinery C. Both A and B are correct D. None of the above 21. D-rings and snap-hooks must have a minimum tensile strength of: - 5,000 pounds 22. Horizontal lifelines shall be designed, installed, and used under the supervision of a _______ as part of a complete personal fall arrest system, which maintains a safety factor of at least two. - Qualified Person23. Preventing fall hazards is a critical part of the construction planning process. Controls to mitigate fall hazards include installing which of the following? - A. Guardrails B. Walls C. Protective covers D. Parapets E. All of the above