nccer test study guide exam questions and answers

nccer test study guide exam questions
and answers
Trigger lock - CORRECT ANSWER-When using power tools t=you never engage the
______________

disconnect the power source - CORRECT ANSWER-before replacing things like bits,
blades, discs or any tool you must

drill bit - CORRECT ANSWER-most hammer drills will not hammer unless pressure is
applied to the ________

a power source is unavailable - CORRECT ANSWER-a pnuematic drill is commonly
used when _______________

the guard protects you from touching the blade - CORRECT ANSWER-never use a
circular saw that dosen;t have an upper blade guard because _______________.

kerf - CORRECT ANSWER-when using a curcular saw be sure to cut on the waist side
of the cut mark to allow for the blade's ____

saber saws - CORRECT ANSWER-saw with fine blades that are excellent for intricate
cutting are called __________.

the power switch is in the off position - CORRECT ANSWER-before you plug any saw
into a power source make sure __________________

band saw - CORRECT ANSWER-a saw that has a thin one piece blade that runs
around a guide is called ___________________.

a circular saw - CORRECT ANSWER-a power miter saw combines a miter box with
_____________

hard and heavy materials - CORRECT ANSWER-an angle grinder is used to grind

1/8 of an inch - CORRECT ANSWER-that adjustable tool rest on a bench grinder
should be positioned ____________ on the grinding wheel

a ring test - CORRECT ANSWER-a good way to check the condition of a grinding wheel
on a bench grinder is to perform ____________________.

burr bits - CORRECT ANSWER-a grinder can catch on rough material edges and shift
around especially when you are using rotary bits called