7 Suspension and Steering Technology Exam Questions And Answers (Updated And Verified)

7 Suspension and Steering Technology Exam Questions And Answers (Updated And Verified) Adjusting nut - answera nut on a worm-type steering gearbox that is used to set worm shaft bearing preload adjusting screw - answera screw on a worm-type steering gearbox that is used to set the sector shaft clearance ball guides - answerchannels that route extra ball bearings in and out from between the worm and ball nut in a recirculating-ball gearbox ball nut - answergrooved nut that rides on the ball bearings and the worm gear in a recirculating-ball gearbox center link - answersteel bar used to connect the pitman arm to the tie-rods in a parallelogram steering system collapsible steering column - answertype of steering column that crumples or slides together when forced forward during a collision to help prevent drive chest and face injury constant-ratio gearbox - answergearbox that uses the same gear reduction when steering from full left to full right control valve - answervalve that controls the application of hydraulic pressure within a power piston in a power steering system electronic four-wheel steering systems - answertype of four-wheel steering system that has an electric-motor-driven power rack that acts upon the rear wheels via its own recirculating-ball drive and mechanical links electronic steering assist - answera small electric motor mounted inside a rack housing that acts upon the rack to aid the driver in steering end cover - answera cap that bolts on a gearbox housing to secure the end of the sector gear external cylinder power steering system - answerpower steering system with the power piston assembly as a separate part bolted to the vehicle frame and center link