Steering and suspension Exam 2 Questions With Verified Solutions

Steering and suspension Exam 2 Questions With Verified Solutions. The circuit to the airbag inflation module is connected from the steering column to the steering wheel through which component? - answerClockspring (coil) Which part in the steering column allows for changes in the angle between the upper and lower shafts? - answerUniversal joint The rotation of the steering wheel causes which part to move the actual steering linkage in a conventional steering gear? - answerPitman arm The pitman shaft is also called the ________. - answerSector The driver rotates the steering wheel one-half of one revolution on a vehicle equipped with a steering gear with a 20:1 gear ratio. How many degrees will the front tires be rotated? - answer9 degrees What causes a variable ratio steering gear to be able to change the ratio as the steering wheel is turned? - answerChanging the length of the teeth on the sector gear Recirculating steel balls are used in most conventional steering gears because they ________. - answerReduce friction Which conventional steering gear adjustment should be the first performed? - answerWorm bearing preload The two rack and pinion steering gear adjustments include ________. - answerPinion bearing preload and rack support A driver of a vehicle equipped with a rack and pinion steering gear complains that the steering wheel jerks whenever the vehicle is being driven into a curbed driveway. Technician A says that the rack and pinion gears may have too little clearance between the teeth of the gears. Technician B says that a lack of lubrication of the rack and pinion is the most likely cause. Which technician is correct? - answerNiether jerks Technician A says that the horn is wired in parallel with the horn switch. Technician B says that a relay is commonly used to control horn operation. Which technician is correct? - answerTech B only horn Which gas is used to fill the airbag during airbag deployment? - answerNirtogen