SUSPENSION AND STEERING Exam Questions With Verified Answers.

SUSPENSION AND STEERING Exam Questions With Verified Answers. Two technicians are discussing the replacement of an inner tie rod end (ball-socket assembly) of a rack-and-pinion steering gear. Tech A says that the inner and outer tie rods ends are part of the rack and cannot be replaced separately. Tech B says the steering gear unit should be removed from the vehicle before the inner tie rod end can be removed. Which Tech is Correct ? - answerNeither Tech A or B A customer complains that the steering lacks power assist only when cold. Tech A says the power steering fluid may be low. Tech B says a worn housing around the rotary (spool) valve is the most likely cause. Which tech is correct? - answerTech B only A defective upper strut mount can cause - answerBinding noise when driving over bumps poor steering wheel return after turning a corner A defective upper strut mount can cause Binding, noise when driving over bumps poor steering wheel return after turning a corner, but will not cause - answera crooked steering wheel a light film of oil is observed on the upper area of a shock absorber. Tech A says that this condition should be considered normal. Tech B says that the rod seal may bleed fluid during cold weather causing the oil to firm, which tech is right? - answerBoth A rear wheel drive vehicle equipped with front coil springs and rear leaf springs is sagging down at the right rear and left front is higher then the right front. Which is most likely the cause. - answera broken leaf spring on the right rear The rear of a sport utility vehicle is sagging. Which is the least likely cause. excessive load in the rear of vehicle incorrect springs broken spring seats leaking shock absorber - answerleaking shock absorber