NCCO TEST 2 WITH QUESTIONS AND WELL ELABORATED CORRECT ANSWERS 100% VERIFIED BY EXPERTS AS C OMPLETELY CORRECT LATEST UPDATE 2024 [GRADED A+] REAL EXAM 100%

NCCO TEST 2 WITH QUESTIONS AND WELL ELABORATED CORRECT ANSWERS 100% VERIFIED BY EXPERTS AS C OMPLETELY CORRECT LATEST UPDATE 2024 [GRADED A+] REAL EXAM 100% When making a multiple crane lift it is important for the operator to understand that: The weight may increase if the other crane lands the load. If a crane is not set-up level and the operator swings a load from the high side, the load radius will: Increase. Most crane manufacturers reduce load capacity for duty-cycle operations because: Side-loading forces may occur. On whose recommendations should preventative maintenance program be set-up: C rane manufacturer. What is the standard rope used on most cranes? Right regular lay. The proper way to calibrate a boom angle indicator is: Using a level, raise the boom horizontal and set the indicator at 0º. The red area of a instrument gauge means: A dangerous condition exists. The best way to keep people from being injured from the counterweight of crane is to: Fence or barricade the tail swing area of the crane. Only approved attachments or extra counterweights made by the manufacturer should be placed on the rear of the crane because: They could cause a backward stability problem. What is the first thing an operator should do before going under a low pipe rack? Post a signal person to check clearance. When working on outriggers, the only time they should be less than fully extended is when: There is a load chart for this operation. When lifting loads from the water, the operator should be aware that: The load will increase when you pick the load from the water. What is required to be on a hydraulic crane in order for it to lift a manbasket? Boom length indicator. When working on rubber, cranes are rated at what percentage of tipping? 75% When using cable or nylon spreaders it