FANUC TEST
What combination is used to record a program point - ANS-Shift point
When creating a program which hard key should be pressed - ANS-Select
Shift and the hard key COORD will display the following menu - ANS-"Jog" menu
In motion command if you want to change joint to linear what do you press -
ANS-Component then choice
Which soft key is pressed to display the current motion instruction - ANS-INST
What is the suggested type of motion used to move the robot to a home position -
ANS-Joint
The detail soft key enables you to modify the following program information except -
ANS-Active tool frame
In a tool frame there are three methods to choose from witch is not a method - ANS-The
seven point method
Identify the motion instruction elements - ANS-Motion, position,speed,termination
Are you able to have more than nine axes in the same group - ANS-NO
Name two ways to control the robots motion limits/boundaries - ANS-Axis limits/ hard
stops and software
When the fault light is red and there are multiple faults what menu should've you be in to
see all current faults - ANS-Alarm
The edit button displays what - ANS-Active program
To use the current default motion instruction press what - ANS-Shift point
To select a new default motion instruction and enter it into a program press what ? -
ANS-Point enter
What combination is used to record a program point - ANS-Shift point
When creating a program which hard key should be pressed - ANS-Select
Shift and the hard key COORD will display the following menu - ANS-"Jog" menu
In motion command if you want to change joint to linear what do you press -
ANS-Component then choice
Which soft key is pressed to display the current motion instruction - ANS-INST
What is the suggested type of motion used to move the robot to a home position -
ANS-Joint
The detail soft key enables you to modify the following program information except -
ANS-Active tool frame
In a tool frame there are three methods to choose from witch is not a method - ANS-The
seven point method
Identify the motion instruction elements - ANS-Motion, position,speed,termination
Are you able to have more than nine axes in the same group - ANS-NO
Name two ways to control the robots motion limits/boundaries - ANS-Axis limits/ hard
stops and software
When the fault light is red and there are multiple faults what menu should've you be in to
see all current faults - ANS-Alarm
The edit button displays what - ANS-Active program
To use the current default motion instruction press what - ANS-Shift point
To select a new default motion instruction and enter it into a program press what ? -
ANS-Point enter
