Millwright Power Tools Exam 2024 Expected Questions and Answers (Verified by Expert)

Millwright Power Tools Exam 2024 Expected Questions and Answers (Verified by Expert) Millwright Power Tools Exam 2024 Expected Questions and Answers (Verified by Expert) Millwright Power Tools Exam 2024 Expected Questions and Answers (Verified by Expert) Millwright Power Tools 2024Expected Questions and Answers (Verified by Expert) 1. Drill Press ANSWER Consists of a starionary mounted drill, a drive motor, an adjustable table, and the necessary controls, all mounted on a column with a base that is fastened to the floor or to the bench. 2. Usually has some type of vise arrangement that fits in the table to hold the work being drilled. Special jigs are used to hold odd-shaped objects on the table. ANSWER The Drill Press 3. Is adjusted by positioning the belt on the appropriate pulley. ANSWER The speed of the drill 4. When operating any type of drill press, lighten the feed pressure ? ANSWER Just before you breakthrough (also called piercing) the pierce. 5. Hydraulic presses can be vertical or horizontal, but the type is the most common? ANSWER Vertical 6. Shop presses vary in size from to capaci- ties and may be hand pumped or have electric pump to power the cylinder ANSWER 5-, 60-Ton 7. Can produce a great amount of pressure. If an excessive amount of pressure is applied to a part, the part could reach the breaking point without any visible indication that too much pressure is applied. ANSWER Hydraulic Presses 8. The only way to determine the amount of pressure being exerted by the hydraulic press is to? ANSWER Watch the pressure Gauge 9. Are designed with a gear drive and chucks, which hold and turn the pipe, and a three-position selector switch consisting of forward, off, and reverse drive positions. ANSWER All pipe threading machines 10. Depending on size and complexity of the machine, pipe threading ma- chines can be mounted on , tables or special stands. ANSWER Tripods 11. Come in a variety of models, from basic gear-drive type with front and rear pipe-holding chucks to the all-purpose model with built in cutters, oilers, reamers, and a pipe threading die. ANSWER Pipe threading machines 12. Loading pipe into threading machine step 4 ANSWER Turn the centering device clock- wise to tighten it 13. Loading pipe into threading machine step 5 ANSWER Turn the handwheel counter- clockwise to tighten the chuck jaws. A counterclockwise turn tightens the jaws on the pipe. A clockwise turn releases the jaws. 14. There are sets of dies that are used to thread pipe up to 2 inches in diameter. ANSWER 4 15. One set of that is used to thread pipe n diameter and larger. ANSWER 21/2 inches 16. are classified according to the number of threads per inch. ANSWER Dies