The footing or anchorage for scaffolds must be capable of carrying
the maximum intended load without:
Tying or guying
Erectors of a scaffold who exposed to potential falling object
hazards shall be provided with:
Over head protection
Previous
Play
Next
Rewind 10 seconds
Move forward 10 seconds
Unmute
0:00
/
0:15
Full screen
Brainpower
Read More
Osha requires a rest landing at intervals not exceed:
35 feet
The top handrail of a scaffold must be able to withstand how many
pounds of pressure?
200
When Building a scaffold inside a "goggle area"
Everyone inside the area must wear goggles
The ladder should be located on a mobile scaffold will not
tip over
When should ties be installed?
During the erection process
What body produces the primary Code or regulations guiding the
scaffolding industry?
OSHA (Occupational Safety and Healthy Agency)
What should be used to erect scaffolding on uneven ground?
Leveling Jacks
OSAH specifically prohibits the use of?
Lean to scaffolds
Boards or wooden pad placed on the soil to support scaffold legs are?
, Mudsills
The tube of a tube and clamp scaffold is normally what size O.D.?
1.9 Inches
Scaffold decks that overlap a minimum of how many inches, unless
secured in some other way?
12
the bearer in a tube and clamp scaffold is always?
Placed above the adjacent runner.
What must a rolling scaffold have on each caster or roller?
Positive locking device
Who must inspect a scaffold each work shift and after any occurrence
which could effect a scaffold's structural integrity?
Competent person
What is the minimum tensile strength of D-rings and snap hooks on a
safety harness?
5,000 pounds
What part of the picture is identified by the letter "G"?
Sill or mudsill
what part of the scaffold is identified by letter "A"?
Guardrail
What part of the scaffold is identified by the letter "C"?
Runner
What part of the scaffold is identified by the letter "F"?
Base plate
When is it allowed to notch out scaffold planks to make them fit?
"Never"
When erecting a scaffold, the screw jack fir the adjustable leg base
should not extend more than how many inches?
12 Inches
Which of the following should be used to safely secure scaffold
boards to the platform?
#9 tie wire and toe boards
According to OHSA, scaffold erection, movement, alteration, and
dismantling must be supervised by who?
Competent person
All of the following safety device should be used when a worker is
using a circular saw except?
Ground Fault Circuit Interrupter (FGCI)
The handle of a claw hammer near the wedge should not be covered
because the covered handle will?
Hide any damages
Safe use of any type of wrench Requires it to be?
Pushed away from the body
the maximum intended load without:
Tying or guying
Erectors of a scaffold who exposed to potential falling object
hazards shall be provided with:
Over head protection
Previous
Play
Next
Rewind 10 seconds
Move forward 10 seconds
Unmute
0:00
/
0:15
Full screen
Brainpower
Read More
Osha requires a rest landing at intervals not exceed:
35 feet
The top handrail of a scaffold must be able to withstand how many
pounds of pressure?
200
When Building a scaffold inside a "goggle area"
Everyone inside the area must wear goggles
The ladder should be located on a mobile scaffold will not
tip over
When should ties be installed?
During the erection process
What body produces the primary Code or regulations guiding the
scaffolding industry?
OSHA (Occupational Safety and Healthy Agency)
What should be used to erect scaffolding on uneven ground?
Leveling Jacks
OSAH specifically prohibits the use of?
Lean to scaffolds
Boards or wooden pad placed on the soil to support scaffold legs are?
, Mudsills
The tube of a tube and clamp scaffold is normally what size O.D.?
1.9 Inches
Scaffold decks that overlap a minimum of how many inches, unless
secured in some other way?
12
the bearer in a tube and clamp scaffold is always?
Placed above the adjacent runner.
What must a rolling scaffold have on each caster or roller?
Positive locking device
Who must inspect a scaffold each work shift and after any occurrence
which could effect a scaffold's structural integrity?
Competent person
What is the minimum tensile strength of D-rings and snap hooks on a
safety harness?
5,000 pounds
What part of the picture is identified by the letter "G"?
Sill or mudsill
what part of the scaffold is identified by letter "A"?
Guardrail
What part of the scaffold is identified by the letter "C"?
Runner
What part of the scaffold is identified by the letter "F"?
Base plate
When is it allowed to notch out scaffold planks to make them fit?
"Never"
When erecting a scaffold, the screw jack fir the adjustable leg base
should not extend more than how many inches?
12 Inches
Which of the following should be used to safely secure scaffold
boards to the platform?
#9 tie wire and toe boards
According to OHSA, scaffold erection, movement, alteration, and
dismantling must be supervised by who?
Competent person
All of the following safety device should be used when a worker is
using a circular saw except?
Ground Fault Circuit Interrupter (FGCI)
The handle of a claw hammer near the wedge should not be covered
because the covered handle will?
Hide any damages
Safe use of any type of wrench Requires it to be?
Pushed away from the body
