BBS 200 AVANCED BALLISTICS SDI | 100% Correct | Verified | 2024 Version

After a bullet leaves the rifle barrel, what two forces act on the bullet's trajectory gravity and the force due to the air Which reloading scale is accurate, inexpensive, and not affected by changes in atmospheric pressure? a. An electronic scale b. A beam scale c. A kitchen scale d. A spring scale A beam scale The sizing die is ________ and needs to be fitted into an appropriate reloading press. a. Temperature-sensitive b. Cartridge-specific c. Crimped d. Thermocoupled Cartridge-specific Full-length sizing die setup begins by inserting the ______ into the top of the press's ram. a. Trim dieb. Decapping pin c. Case lube d. Shellholder Shellholder The measurement for overall case length is taken from the flat of the case head to the opening of the case mouth, and the length is always expressed as a maximum dimension less _____________. a. Ten-thousandths of an inch b. One-tenth of an inch c. One one-thousandths of an inch d. Ten-thousandths of a milliliter Ten-thousandths of an inch Which process compresses metal and reforms it to a specified dimension? a. Soft-seating b. Cam-over c. Decapping d. Resizing Resizing What is the proper name for a bullet tip a. The meplat b. The camc. The head d. The point The meplat What is the name for backing off the ram slightly and screwing in the die an additional 1/8- to ¼-turn? a. Soft-seating b. Cam-over c. Decapping d. Crimping Cam-over True or False The cleaning of the primer pocket cannot be done