Gas Tech II Exam || All Questions Answered Correctly.

1) What is the minimum diameter of a pressure gauge needed to perform leak test on gas piping? correct answers 3" 2) Amp meter can read what? correct answers Conductor magnetic field. 3) What would be the primary voltage of a furnace? correct answers 120/1/60. 4) What is the function of an intermittent pilot? correct answers Stay on during the main burner operation. 5) What is the millivolts power output on a thermocouple closed circuit test? correct answers 10 to 15 millivolts. 6) A pilot with a lazy yellow flame would indicate? correct answers Orifice size too large. 7) For flame rectification one of the most important things should be? correct answers Proper grounding plane. 8) What makes a flame capillary sensor tube prove pilot to main gas valve? correct answers Pilot flame. 9) Since 1996 the most common type of home construction? correct answers Platform. 10) Can a new installation of a fin type pool heater less than 250,000 btu be installed in a house? correct answers Yes, if pool heater is direct vented. 11) When converting oil furnace to gas what type of atmospheric burner can be use? correct answers Inshot. 12) If the flue gases are remove from the front of the appliance we could assume that it's a? correct answers 2 to 4 flue pasts boiler. 13) Can a gas log set be installed in sleeping quarters? correct answers Yes, if approved by the manufacturer. See clause 7.24.4(c). 14) What is the minimum distance that a vent from an appliance with an input of 110,000 btuh can be from a non-mechanical air supply? correct answers 3ft 15) If the boiler flue gases are remove from the front of the appliance we could assume that it's a? correct answers 2 to 4 flue pass boiler. 16) Can a gas log fire place be installed in a sleeping quarter? correct answers No, even if new venting is installed.