2024 PA Appraisers License
Exam / PA Appraisers License
Exam Questions and Answers
(100% Satisfied) 2024
,How is a diamond condition fixed? - CORRECT ANSWER-By
pulling the damage for length. Diamond is a length condition
When measuring a unibody vehicle, it is discovered that the
left front rail is 111mm from spec in width. What condition is
this? - CORRECT ANSWER-Width is calculated from the
center out, so a value of -111mm on the left rail shows sway
to the right and in toward centerline
A collision-damaged vehicle is discovered to be down in
height at the opposite end of the center section. What
condition is this frame in? - CORRECT ANSWER-Twist
condition
When diagnosing the damage to a full frame assembly on a
sport utility vehicle, it is determined that the left side frame
rail is higher than the right side frame rail. Technician A says
the damaged state is known as a twist condition. Technician
B says a sway condition exists. Who is right? - CORRECT
ANSWER-Tech A. When a frame rail's relationship to the
vehicle centerline is changed, such as pushed either to the
left or
right, the condition is known as sway. "Twist" refers to the
condition of the frame when entire sections are driven higher
or lower than the opposite side.
,Metal fillers contain different ingredients that provide fillers
with special properties. What benefit does fiberglass
provide? - CORRECT ANSWER-Fiberglass offers more
resistance to moisture
, What does HSLA stand for? - CORRECT ANSWER-High
Strength Low Alloy
When replacing the floor pan in the trunk area, what joint
should be used to join the new pan to the existing floor? -
CORRECT ANSWER-Overlap joint
When acoustical foam is removed during the repair, what
must happen afterwards? - CORRECT ANSWER-Replace the
acoustical foam
When setting up a three-dimensional measuring system, it
should be setup on an undamaged area, and start with what
section? - CORRECT ANSWER-Starting in the center section
What is the plastic Black box in rear of the car? - CORRECT
ANSWER-Vapor Canister
Grinding or squeaking from a wheel is a sign of what? -
CORRECT ANSWER-Bad bearings
Exam / PA Appraisers License
Exam Questions and Answers
(100% Satisfied) 2024
,How is a diamond condition fixed? - CORRECT ANSWER-By
pulling the damage for length. Diamond is a length condition
When measuring a unibody vehicle, it is discovered that the
left front rail is 111mm from spec in width. What condition is
this? - CORRECT ANSWER-Width is calculated from the
center out, so a value of -111mm on the left rail shows sway
to the right and in toward centerline
A collision-damaged vehicle is discovered to be down in
height at the opposite end of the center section. What
condition is this frame in? - CORRECT ANSWER-Twist
condition
When diagnosing the damage to a full frame assembly on a
sport utility vehicle, it is determined that the left side frame
rail is higher than the right side frame rail. Technician A says
the damaged state is known as a twist condition. Technician
B says a sway condition exists. Who is right? - CORRECT
ANSWER-Tech A. When a frame rail's relationship to the
vehicle centerline is changed, such as pushed either to the
left or
right, the condition is known as sway. "Twist" refers to the
condition of the frame when entire sections are driven higher
or lower than the opposite side.
,Metal fillers contain different ingredients that provide fillers
with special properties. What benefit does fiberglass
provide? - CORRECT ANSWER-Fiberglass offers more
resistance to moisture
, What does HSLA stand for? - CORRECT ANSWER-High
Strength Low Alloy
When replacing the floor pan in the trunk area, what joint
should be used to join the new pan to the existing floor? -
CORRECT ANSWER-Overlap joint
When acoustical foam is removed during the repair, what
must happen afterwards? - CORRECT ANSWER-Replace the
acoustical foam
When setting up a three-dimensional measuring system, it
should be setup on an undamaged area, and start with what
section? - CORRECT ANSWER-Starting in the center section
What is the plastic Black box in rear of the car? - CORRECT
ANSWER-Vapor Canister
Grinding or squeaking from a wheel is a sign of what? -
CORRECT ANSWER-Bad bearings
