CDT Comprehensive Exam Questions With 100% Correct Answers 2024

CDT Comprehensive Exam Questions With 100% Correct Answers 2024 Overjet is defined as - answerhorizontal overlap. What is the MOST likely cause for breaking a denture reline when removing the cast - answerundercuts were not removed before the cast was poured Distoclusion describes a _______________ occlusion - answerclass II The rear most, upper most, midmost position of the mandible in the articular fossa is - answercentric relation The bilateral curve in which molars are set is called - answerthe Curve of Wilson What is the process of replacing all palatal acrylic without disturbing existing denture teeth? - answerrebasing What is the MOST likely cause for porosity after processing and deflasking a denture? - answerthe curing temperature was too high or the flask was underpacked An articulator that has adjustable but straight lateral and protrusive guidance is called a - answersemi-adjustable articulator. Wax festooning is the process of - answeranatomically waxing the denture anatomically waxing the denture - answerthe central fossa of the maxillary first molar Mutually protected occlusion has posterior contacts in - answercentric During denture flask wax elimination, immersion in the boilout tank for too much time may result in what outcome? - answerthe wax to melt and soak into the mold In Class I centric occlusion, the maxillary anterior teeth occlude with - answerthe facio- incisal edge of mandibular anterior teeth The____ is where the two centrals line up and is marked by the dentist - answermidline The mesiobuccal cusp of the maxillary first molar is in alignment with the mesiobuccal groove of the mandibular first molar in what type of occlusion? - answerclass I What is the process used to resurface the tissue side of a denture with new base material for a better fit? - answerrelining Monomer is a - answerliquid for mixing methyl methacrylate/acrylic. The mandibular second premolar contacts the - answermaxillary first and second premolars. Which of the following is found on the maxilla? - answertuberosity According to cusp-fossa theory, cusps tips will not wear away because - answercusp tips do not actually occlude with opposing dentition The Curve of Spee - answeris the anterior-posterior curvature of the occlusal surfaces of mandibular teeth. What is the proper order or operations after receiving a denture back from the dentist with impression material on the tissue surface? - answerbox impression, trim cast, cut notches, blockout undercuts Polymerization of the denture means - answercuring the denture base The rear most, upper most, midmost position of the mandible in the articular fossa is - answercentric relation When finishing complete dentures, what should the pumice be applied to? - answerdirectly to the object being polished Which statement best describes the movements in the temporomandibular joint during centric occlusion, protrusion and retrusion? - answerMovements occur bilaterally simultaneously and in the same direction What is the MOST important reason to allow the gypsum cast to fully set? - answeravoid loss of surface detail. Monomer is a - answerliquid for mixing methyl methacrylate/acrylic. The mandibular second premolar contacts the - answermaxillary first and second premolars. The mesiobuccal cusp of the maxillary first molar is in alignment with the mesiobuccal groove of the mandibular first molar in what type of occlusion? - answerclass I Where are the synovial cavities located? - answeras part of the TMJ What is the MOST likel