MSSC Quality Systems Part 2 Accurate 100%(RATED A+)

Automated part inspection commonly uses __________. - ANSWERvision systems Parts labeled ______ should be inspected to determine if they should be reworked or scrapped. - ANSWERhold _____________ inspections assure that the equipment, personnel and processes being used are providing the desired results and allow systems to be pinpointed and solutions implemented before the problem can escalate. - ANSWERIn-process When parts need further inspection they should be labeled as ______. - ANSWERHold Red tags are typically attached to parts that are __________. - ANSWERscrapped The cost of a product's raw materials does not typically determine if __________. - ANSWERthe product is non-conforming Parts that are labeled as ok To ship must _________. - ANSWERmeet compliance Measurement of product quality attributes can be assisted by performing __________. - ANSWERdaily quality and equipment checks The sampling plan uses a(n) _________ chart that indicates to an inspector the number of parts to inspect based on the size of the product batch. - ANSWERfrequency Certain characteristics of parts are essential for its proper operation. Identifying these characteristics as _______ helps set up a meaningful quality inspection program. - ANSWERcritical An engineering change notice (ECN) is used to notify changes to __________. - ANSWERa product drawing The review of audit procedures and instructions are control and planning functions within a(n) __________. - ANSWERtraceability program A ___________ is used to verify that the proper procedures and processes are being adhered to by plant personnel. - ANSWERquality audit program Instrument reliability is examined to determine _____________________. - ANSWERcalibration intervals