MSSC Quality Systems Questions & Answers(RATED A)

Automated part inspection commonly uses __________. -ANSWER vision systems Parts labeled ______ should be inspected to determine if they should be reworked or scrapped. -ANSWER hold _____________ inspections assure that the equipment, personnel and processes being used are providing the desired results and allow systems to be pinpointed and solutions implemented before the problem can escalate. -ANSWER In-process When parts need further inspection they should be labeled as ______. -ANSWER Hold Red tags are typically attached to parts that are __________. -ANSWER scrapped The cost of a product's raw materials does not typically determine if __________. -ANSWER the product is non-conforming Parts that are labeled as ok To ship must _________. -ANSWER meet compliance Measurement of product quality attributes can be assisted by performing __________. -ANSWER daily quality and equipment checks The sampling plan uses a(n) _________ chart that indicates to an inspector the number of parts to inspect based on the size of the product batch. -ANSWER frequency Certain characteristics of parts are essential for its proper operation. Identifying these characteristics as _______ helps set up a meaningful quality inspection program. -ANSWER critical An engineering change notice (ECN) is used to notify changes to __________. -ANSWER a product drawing The review of audit procedures and instructions are control and planning functions within a(n) __________. -ANSWER traceability program A ___________ is used to verify that the proper procedures and processes are being adhered to by plant personnel. -ANSWER quality audit program Instrument reliability is examined to determine _____________________. -ANSWER c