Oregon Tattoo Test Exam Questions and Answers 100% Pass

Oregon Tattoo Test Exam Questions and Answers 100% Pass a-bar - Answer- abbreviation for armature bar aligned - Answer- armature bar and rear coil should be ____________ more leverage - Answer- an a-bar extending past rear coil creates _________ 1.5-1.625 - Answer- usually a longer armature bar is a range from _.___ to _.____ plain steel, no chrome - Answer- armature bars should be _________ ________, _____ ____________ .010-.012 - Answer- when a-bar is flat on coil, rear coil has between .___-.___ dust, lint, debris, hitting at an angle - Answer- what can cause a rattle or deflection of a- bar? (4 things) run hot - Answer- coils with too much core showing tend to ____ _____ buzz or rattle - Answer- do not allow the front spring to hang over the rear of the armature bar because it can create a ______ or ___________ contact screws - Answer- there should be no sharp edges on __________ _______, should be rounded and very smooth faster - Answer- a short front spring will be _________ rockwell scale - Answer- all metals are measured on the _________ _______ 48-51 - Answer- best on the scale for spring stock is ___-___ alcohol - Answer- can be used to clean your contact area and screws and spring rattle - Answer- thin, cheap binding posts cause ________ leverage - Answer- _____________ is a key factor when it comes to a-bar choice 100 - Answer- copper is ___% conductive copper and zinc - Answer- brass is a mixture of 6-32, 8-32 - Answer- some machines have _-__ threaded machine screws and some have _-__ thicker binding posts - Answer- _________ __________ ______ help dampen vibrations shorter - Answer- is a shorter or longer front spring better on a liner? shoulder washers - Answer- screw insulators commonly known as __________ __________ , most common are made of fiber and plastic true - Answer- a longer A-Bar has more leverage, true or false? electrical contact to contact screw - Answer- purpose of the binding post rubber grommets - Answer- dampener or rubber grommets better? hot - Answer- never use brass screws or any other non-ferrous screws for the coil screws can cause the coils to get ___ soldering lugs - Answer- ______________ ____ are soldered at the ends of the coil wires and capacitor wires, with a 5/16" tube vise liners - Answer- tattoo machine capacitors have 22 MFD for ________ shaders - Answer- tattoo machine capacitors have 47 MFD for _________