CMSP TEST QUESTIONS WITH COMPLETE ANSWERS
CMSP TEST QUESTIONS WITH COMPLETE ANSWERS Give three reasons why motorcycling is more risky than driving a car? -Answer-1- motorcycles are more vulnerable than cars 2-they are harder to see than cars 3-you are exposed to the elements What is rider readiness -Answer-Being mentally focused, physically fit, wear proper riding gear, know your limitations, awareness of conditions, and knowing your motorcycle What does it mean that to "accept your responsibility"? -Answer-Ride within your limits and the bike's to reduce the risk of motorcycling and set an example. What is the benefit of wearing apparel specifically designed for motorcycling? -Answer- How does riding gear make a rider more comfortable? -Answer-With some jackets you are able to adjust the amount of wind you want and you can button down straps to avoid them flapping in the wind. What is the difference between retro-reflective and reflective? -Answer-Reflective reflects the light in any which way,retro-reflective directs the light back to the source. Why aren't ordinary sunglasses or sunglasses sufficient eye protection? -Answer-Might shatter upon impact What three things should you consider when shopping for riding gear? -Answer- Where do you find the recommended maintenance schedule for your motorcycle? -Answer-In the motorcycle operation manual ( MOM). What are the five primary controls and where is each located? -Answer-Throttle, clutch lever, gearshift lever, front brake lever, rear brake pedal What is the purpose of the engine cut off switch and where is it located? -Answer-To avoid taking your hands off the bar in a situation where control is critical and you need to turn off the engine. Located on the right side of the handlebars. What must you remember when your motorcycle turn signal? -Answer-To turn it off after you have completed the movement. What is the significance of ONE-C? -Answer-O- turn the petcock and ignition ON N- make sure the bike is in NEUTRAL E- move the ENGINE cut off switch to ON C- cover the CLUTCH and if the engine is cold turn the CHOKE to the on position. What is SPAT? -Answer-S-decrease SPEED P- set your body into POSITION A- look and AIM where you are going T- complete the movement and TURN What is ONE-C used for? -Answer-Pre start checklist to start the engine What is SPAT used for? -Answer-Turning maneuvers What is counter-steering? Why is it important? -Answer-A way of steering, it is a more reliable way of steering at speed. When should you lean with your bike? -Answer-Higher speed turns When should you counter the lean of your bike? -Answer-Lower speed turns What is the friction zone? What is it used for? -Answer-The point where the clutch starts to grab Describe good riding posture -Answer-Straightened back, eyes up, feet on foot rests, knees against the tank, relax your arms and bend your elbows a little. How can you improve your visibility to other traffic? -Answer-Have bright clothes, ride with your headlight on, use your turn signals, fla
Written for
- Institution
- CMSP
- Course
- CMSP
Document information
- Uploaded on
- February 3, 2024
- Number of pages
- 5
- Written in
- 2023/2024
- Type
- Exam (elaborations)
- Contains
- Questions & answers
Subjects
-
cmsp test questions with complete answers