MSSC Quality Practices & Measurement Questions and Answers Already Passed

MSSC Quality Practices & Measurement Questions and Answers Already Passed Which type of feature is parallel to the surface being dimensioned? - Answer ️️ -Dimension line The three standard views of an object are __________. - Answer ️️ -Top, front, right side Which type of lines are used to show the counterbored hole in the part? - Answer ️️ -Hidden lines The number of views in a drawing __________. - Answer ️️ -Is the fewest number that shows all of the features and dimensions Which of the following steps is NOT used in the glass box method? - Answer ️️ -Rotate object in glass box. What type of drawing is shown? - Answer ️️ -Multiview The dimensions of raw material supplied by metal suppliers are described by the __________. - Answer ️️ -Stock size Which of these requires a computer? - Answer ️️ -CAD An isometric drawing is a type of __________. - Answer ️️ -Pictorial drawing In the graphic shown, the two circles are __________. - Answer ️️ -Concentric Dimensions are used to specify the __________ and location of the features of an object. - Answer ️️ -Size What feature in the figure shown is a Chamfer? - Answer ️️ -D A __________ dimension is described in inches per foot. - Answer ️️ -Shaft taper What is the order of precedence of lines in a drawing? - Answer ️️ -Object, Hidden, Center Which of the following is not one of the six rules for dimensioning an object? - Answer ️️ - Dimension hidden lines Engineers sometimes use a __________ to measure angles on a drawing. - Answer ️️ - Protractor What dimension is indicated in this graphic? - Answer ️️ -Height There are 60 minutes of arc in one __________. - Answer ️️ -Degree In manufacturing, a blueprint is also called what? - Answer ️️ -A technical drawing The distance across the flats of the hex head shown in the part drawing is __________ inches. - Answer ️️ -2 ¼ The length of the part shown in the drawing is __________ inches. - Answer ️️ -9 ¾ Which type best describes the line indicated in the graphic? - Answer ️️ -Object Line Which of the following bolts is a grade 2? - Answer ️️ -A The hole shown in the graphic is a __________ hole. - Answer ️️ -Counterbore What are the two types of assembly drawings? - Answer ️️ -Exploded and basic A sectional view __________. - Answer ️️ -All of the abo