dale crane engine overhaul inspection and measurement questions with correct answers

Abrasive blasting _________ (is or is not) a good method to use for cleaning a part that is to be inspected by the fluorescent penetrant method. Page 308 CORRECT ANSWER is not All precision measuring instruments used to overhaul an FAA-certificated aircraft engine must have their accuracy traceable back to the CORRECT ANSWER National Institute of Standards and Technology or National Bureau of Standards The bore diameter of a cylinder may be measured with a/an _______ or by an __________ outside micrometer and a/an. CORRECT ANSWER inside micrometer caliper, telescoping gage Acylinder barrel is measured twice, with the measurements taken at 90° to each other. The difference between the two dimensions is the amount the cylinder is (tapered or out-of-round). CORRECT ANSWER out-of-round The cylinder diameter is measured near the bottom, and again near the top. The difference in these two readings is the _________ of the cylinder. CORRECT ANSWER choke If a part is larger than the hole into which it is to be installed, the fit is called a/an ______ fit CORRECT ANSWER interference Ifthe diameter of a valve stem, measured in the center, is less than it is near the spring retainer groove, the