Sense level 1 welding process certification test module 9: welding inspection and test principles Questions With 100% Correct Answers.

which of the following is not a type of weld joint - fillet the portion of the joint where the two pieces to be joined come closet together is called the - joint root a weld produced by filling an elongated hole in an overlapping member, fusing it to the member beneath is called a - slot weld a weld having a triangular cross section which is applied to a T-joint, corner joint or lap joint is called a - fillet weld a weld used to build up thin surfaces and to provide a layer of corrosion protection and/ or abrasionresistance is called - surfacing weld the height of a weld above the metal in a groove weld is the - weld reinforcement a __________ fillet weld has the same leg and size dimensions - equal leg a weld formed by progressing along the joint with a side-to-side motion is called - weave bead the base material next to the weld that is not melted, but that undergoes structural and metallurgical changes is called - the heat affected zone the problem occurring in weldments due to the non-uniform heating produced by welding is called - distortionthe most common type of destructive testing of weld is called - bend test according to the AWS D1.1 code, if a welder continues to use a particular procedure, how long does his/ her qualification remain - indefinitely, unless the ability of the welder is questioned a weld discontinuity caused by the improper termination of the welding arc is referred to as - crater crack a discontinuity that results from the entrapment of gas within the weld is referred to as - porosity which weld metal discontinuity is generally considered to be the most severe - cracks which weld discontinuity results from weld metal flowing out of the joint and laying on the base metal surface without fusing - overlap