NCCER Module 4 Introduction to Power Tools fully solved to pass

NCCER Module 4 Introduction to Power ToolsA Porta-Power® is an example of a __________tool. hydraulic A power miter saw combines a miter box with a _______saw. circular To prevent electrical shock, power tools should only be operated with the proper? GFCI When using an air wrench, keep your body stance _______. balanced Drill bits are held in place by? chucks The angle grinder is used to grind ________, ________ materials. hard, heavy Before you plug any saw into a power source, make sure the power switch is in the _______position. OFF An example of an AC source of power is a ______receptacle. wall The first step when using a pneumatically powered nailer for the first time is to read the manufacturer's ____________. instructions Saws with fine blades that are excellent for delicate and intricate cutting are called? saber saws Keep the drill's air vent clean with a small _______. brush A ____________drill is used when there is no source of electricity. pneumatic On power tools, you should never engage the trigger __________. lock If a pneumatic nailer is not firing properly, before you attempt repairs you must disconnect the? air hose Before you start drilling, make sure the drill bit is tightened in the? chuck When using a power drill, proper ground fault protection will prevent ________shock. electric Never use a circular saw that doesn't have an upper blade guard because the guard protects you from touching the? blade The adjustable tool rest on a bench grinder should be positioned_______ inch from the wheel. 1/8 Some manufacturers suggest that each time you use a pneumatic nailer, the air inlet needs a few drops of? oil Before replacing parts such as bits, blades, or discs on any tool, you must disconnect the _________source. power