Drawing-Practice-for-QS.pdf

TERTIARY AND VOCATIONAL EDUCATION COMMISSION

COMMON WRITTEN EXAMINATION



All rights reserved
NVQ Level 05 - Semester I
Quantity Surveying



Drawing Practice for Quantity Surveying F45C002M05
Three Hours



* Answer all questions


Question No 01
Annexure 01 and Annexure 2 has shown a plan of a two storied building (both stories fully
same size design - height of the floor 3200m) with 250 mm thick brick walls & corrugated
asbestos cement sheet roofing on timber frame. The slope of roof is 100 & eaves projection is
900 mm from external walls.


Using appropriate scales draw the followings & label properly.


1. Floor Plan (25 Marks)
2. Section through X –X (20 Marks)
3. Front Elevation (25 Marks)
4. Design light points & fan points & mark it on the floor plan (10 Marks)

Assume reasonable values or any suitable assumptions for any data not given& clearly state
such assumptions.

Question No 02

State the most suitable AutoCAD software tool for the following functions
a) Erasing a part of an object.
b) Drawing a parallel line with equal length to given line.
c) Taking a source object to another place.
d) Modifying dimensions.
e) Create a mirrored copy of source object.
(20Marks)