SNSP Exam - Best Practices and other Basics | 85 Questions and Answers(A+ Solution guide)

Which interfaces cannot be configured as WAN interfaces - X0 and MGMT What is the default configuration of X1 - Static mode with IP of 0.0.0.0 To avoid routing issues of X1 what should you ensure - It's assigned with a valid non-zero IP address or configuring for DHCP or PPPoE True or False: It is recommended to disassociate the from the WAN zone if not in use - True - Unassigned True or False: You should open HTTPS Mgmt up on the WAN interface - False True or False: Check the "Add rule to enable redirect from HTTP to HTTPS" option when configuring HTTPM management - False What can result from incorrect duplex settings on the WAN - Inconsistent Internet connection, slow throughput, dropped packets, and inability to negotiate to an ISP connection What settings are default on the advanced tab of a WAN interface - Link Speed to Auto Negotiate User Default MAC address Enable Flow Reporting Fragment non-VPN outbound packets larger than this Interfaces MTU MTU stands for what - Maximum Transmission Unit On DSL and cable connections is the MTU size generally lower or higher - LowerHow do you change the value of MTU - In increments of 8 bytes True or False: Confirm that Ignore Don't Fragment DF bit is unchecked - True True or False: Even if you only have 1 WAN connection you should still enable "Enable Load Balancing" - True Why must you enable load balancing with only 1 WAN connection - To access the LB Groups and LB Statistics sections of Failover and Load Balancing configuration