CCNA practice test questions AND CORRECT ANSWERS

What are the steps to configure a static route CORRECT ANSWERS: Configure unidirectional static routes to and from a stub network Define a path to the IP destination network Question: Which of the following commands will display information about the specific port channel interface? CORRECT ANSWERS: show etherchannel port-channel show etherchannel port-channel CORRECT ANSWERS: Use the [show vlan] command to verify that the port is in the correct VLAN Use the [show mac address-table] command to check which addresses were learned on a particular port and which VLAN that port is assigned You are troubleshooting a connectivity issue on the Branch router when you realize that a ping test to the destination network is not successful. The Branch and corresponding HQ router have their neighbor adjacency set up. What could be the problem? CORRECT ANSWERS: The HQ router isn't advertising the route There is a route missing to the destination in the Branch router`s routing table A user is experiencing a loss of end-to-end connectivity in an IPv4 network. You have verified that there is no physical connectivity issue. Logically, what should you check next? CORRECT ANSWERS: Whether the current path is undesirable