Lineman Apprentice Test | 2026/2027 | A+ Grade
| Questions and Answers | Complete
Apprenticeship Exam Preparation Study Guide
Practice questions for this set
Learn 1 /7 Study with Learn
Subtractive
Choose an answer
What is the standard polarity of a
The difference in a 3 wire & 4 wire
1 2 14.4 transformer that is less than
distribution circuit is?
200 kVA?
When splicing distribution wires,
What are the component parts of a
3 how far should the line be laid out 4
distribution system?
straight before splicing?
Don't know?
Terms in this set (163)
, The difference in a 3 wire & 4 wire the Neutral wire
distribution circuit is?
What is the formula for power P=VxI
Transmission voltage is generally 138,000 to 765,000 volts
_________ to _________.
If the diameter of the pole to be set 16", 3" on each side of the pole
is 10", the diameter of the hole
should be ____ to allow sufficient
room for tamping.
What are the component parts of a Distribution Substation, feeder circuits, switches,
distribution system? protective equipment, primary circuits,
distribution transformers, secondaries, services.
An advantage of a Wye Primary Increased power carrying capacity, better
system over a Delta primary system voltage regulation
is?
The total flow of current from a 20,000
generating plant may be as large as
__________ amps.
| Questions and Answers | Complete
Apprenticeship Exam Preparation Study Guide
Practice questions for this set
Learn 1 /7 Study with Learn
Subtractive
Choose an answer
What is the standard polarity of a
The difference in a 3 wire & 4 wire
1 2 14.4 transformer that is less than
distribution circuit is?
200 kVA?
When splicing distribution wires,
What are the component parts of a
3 how far should the line be laid out 4
distribution system?
straight before splicing?
Don't know?
Terms in this set (163)
, The difference in a 3 wire & 4 wire the Neutral wire
distribution circuit is?
What is the formula for power P=VxI
Transmission voltage is generally 138,000 to 765,000 volts
_________ to _________.
If the diameter of the pole to be set 16", 3" on each side of the pole
is 10", the diameter of the hole
should be ____ to allow sufficient
room for tamping.
What are the component parts of a Distribution Substation, feeder circuits, switches,
distribution system? protective equipment, primary circuits,
distribution transformers, secondaries, services.
An advantage of a Wye Primary Increased power carrying capacity, better
system over a Delta primary system voltage regulation
is?
The total flow of current from a 20,000
generating plant may be as large as
__________ amps.
