Introduction to Programmable Controllers
Study online at https://quizlet.com/_a2mcws
1. The six basic components of most PLCs are the power I/O chassis
supply, the input and output modules, the processor
module, the programming device, and the
2. The three network levels are enterprise, automation Control
and, ___, and field device.
3. The basic operation of a ______ is to scan instructions, PLC
monitor the status of input devices, and produce out-
puts based on which inputs are on or off.
4. The 1769-L16ER controller's USB port is USB ________ 2.0
compatible and operates at 12 Mbps.
5. All PLC's must have a(n) ___ to operate. user developed project
6. A _____ is a file that contains a hardware configuration project
and control program.
7. ____ is an embedded operating system that controls Firmware
how microprocessor-controlled hardware devices op-
erate.
8. Ethernet/IP uses the ____(protocol) to produce a net- CIP
work suitable fore use on automation and control lev-
el.
9. PLCs provide a means of controlling machines and oth- computer
er industrial applications with a(n) ____ instead of using
hard wired devices, such as relay coils and contacts.
10. ______ uses several protocols to convert data from its Ethernet TCP/IP
native format, such as a text message, into a format
1/2
Study online at https://quizlet.com/_a2mcws
1. The six basic components of most PLCs are the power I/O chassis
supply, the input and output modules, the processor
module, the programming device, and the
2. The three network levels are enterprise, automation Control
and, ___, and field device.
3. The basic operation of a ______ is to scan instructions, PLC
monitor the status of input devices, and produce out-
puts based on which inputs are on or off.
4. The 1769-L16ER controller's USB port is USB ________ 2.0
compatible and operates at 12 Mbps.
5. All PLC's must have a(n) ___ to operate. user developed project
6. A _____ is a file that contains a hardware configuration project
and control program.
7. ____ is an embedded operating system that controls Firmware
how microprocessor-controlled hardware devices op-
erate.
8. Ethernet/IP uses the ____(protocol) to produce a net- CIP
work suitable fore use on automation and control lev-
el.
9. PLCs provide a means of controlling machines and oth- computer
er industrial applications with a(n) ____ instead of using
hard wired devices, such as relay coils and contacts.
10. ______ uses several protocols to convert data from its Ethernet TCP/IP
native format, such as a text message, into a format
1/2
