Gate valve
The (gate valve) symbol is used in P&ID diagrams to indi-
cate a:
A piping and instrumentation diagram (P&ID) will show
with all information for those lines
major flow lines:
One of the main types of maintenance is: Preventative
(4-021-1.3) One of the most important features of the first
Show the main proportion of the sketch
lines drawn in a sketch is that they:
Which of these is a key component to MMS (maintenance
Work order system
management system)?
One of the advantages of written communication is: That it can be proof read and edited
One of best practices for writing SOPs is to: Use a standardized template
(4-021-2.2) The three most common views used
in drawings are the front, and Plan, side
views:
The letters LAL inside a circle on a P&ID stands for : Level alarm low
One of the commonly accepted document control best
Have limited circulation of printed copies
practices is to:
Which of these is a reason to NOT use standard operating
Allow operators to use their own methods of a procedure
procedures (SOP)?
A plant line tracing is a that helps Power En-
Single line sketch
gineers to learn a new plant:
If you discover an injured worker in your facility, you
Press the "Man Down" button
should on your two-way radio.
Types of maintenance is classified in the following cate-
Routine, Preventative, Projects, and Emergency
gories:
1/4
The (gate valve) symbol is used in P&ID diagrams to indi-
cate a:
A piping and instrumentation diagram (P&ID) will show
with all information for those lines
major flow lines:
One of the main types of maintenance is: Preventative
(4-021-1.3) One of the most important features of the first
Show the main proportion of the sketch
lines drawn in a sketch is that they:
Which of these is a key component to MMS (maintenance
Work order system
management system)?
One of the advantages of written communication is: That it can be proof read and edited
One of best practices for writing SOPs is to: Use a standardized template
(4-021-2.2) The three most common views used
in drawings are the front, and Plan, side
views:
The letters LAL inside a circle on a P&ID stands for : Level alarm low
One of the commonly accepted document control best
Have limited circulation of printed copies
practices is to:
Which of these is a reason to NOT use standard operating
Allow operators to use their own methods of a procedure
procedures (SOP)?
A plant line tracing is a that helps Power En-
Single line sketch
gineers to learn a new plant:
If you discover an injured worker in your facility, you
Press the "Man Down" button
should on your two-way radio.
Types of maintenance is classified in the following cate-
Routine, Preventative, Projects, and Emergency
gories:
1/4
