CPSGT and RPSGT Exam A (Part 2) Exam Questions with 100%
Correct Answers Latest Graded A+
Question:
Displaced respiratory belts would only impact:
Answer:
respiratory channels.
Question:
A disconnected end-tidal cable (EtCO2) would only impact:
Answer:
the canography (non-invasive measurement of CO2) for channel.
Question:
A contaminated M1 electrode would impact any channel that M1 is paired with,
Answer:
typically F4, C4 and O2 if using montage recommended by AASM.
Question:
The entire systems ability to record clean data depends on:
Answer:
the systems reference electrode remaining solidly connected with a low impedance value. If this is
compromised, all channels will be negatively impacted.
Question:
Due to the fact that EEG cup electrodes typically do not come in contact with mucous membranes
or patient secretions,
Answer:
they require less intensive disinfection techniques.
Question:
Once adhesive, gel or cream and any organic material is removed with a soft bristled brush,
, Answer:
electrodes can be disinfected by soaking in a solution of 1:10 bleach/water for ten minutes and then
hanged to air dry.
Question:
Alcohol and acetone are not recommended as:
Answer:
as adequate methods of EEG cup electrode disinfection.
Question:
Pasteurization is a process that is needed for:
Answer:
equipment that has been in contact with mucous membrane or secretions.
Question:
Policies and procedures will vary between facilities,
Answer:
but it is always important to ensure that a patient maintains adequate oxygenation.
Question:
Allowing for a low SpO2 can be dangerous;
Answer:
implications of allowing a low oxygenation includes increased cardiac arrhythmia, elevated
daytime arterial pressure and poor objective and subjective sleep quality measures.
Question:
Pulse oximetry is a non-invasive method of indirectly monitoring an approximation of a patient's
oxygen level by the use of:
Answer:
sensors that detect light wave absorption through a probe placed on ones finger.
Question:
Arterial blood gas is an:
Correct Answers Latest Graded A+
Question:
Displaced respiratory belts would only impact:
Answer:
respiratory channels.
Question:
A disconnected end-tidal cable (EtCO2) would only impact:
Answer:
the canography (non-invasive measurement of CO2) for channel.
Question:
A contaminated M1 electrode would impact any channel that M1 is paired with,
Answer:
typically F4, C4 and O2 if using montage recommended by AASM.
Question:
The entire systems ability to record clean data depends on:
Answer:
the systems reference electrode remaining solidly connected with a low impedance value. If this is
compromised, all channels will be negatively impacted.
Question:
Due to the fact that EEG cup electrodes typically do not come in contact with mucous membranes
or patient secretions,
Answer:
they require less intensive disinfection techniques.
Question:
Once adhesive, gel or cream and any organic material is removed with a soft bristled brush,
, Answer:
electrodes can be disinfected by soaking in a solution of 1:10 bleach/water for ten minutes and then
hanged to air dry.
Question:
Alcohol and acetone are not recommended as:
Answer:
as adequate methods of EEG cup electrode disinfection.
Question:
Pasteurization is a process that is needed for:
Answer:
equipment that has been in contact with mucous membrane or secretions.
Question:
Policies and procedures will vary between facilities,
Answer:
but it is always important to ensure that a patient maintains adequate oxygenation.
Question:
Allowing for a low SpO2 can be dangerous;
Answer:
implications of allowing a low oxygenation includes increased cardiac arrhythmia, elevated
daytime arterial pressure and poor objective and subjective sleep quality measures.
Question:
Pulse oximetry is a non-invasive method of indirectly monitoring an approximation of a patient's
oxygen level by the use of:
Answer:
sensors that detect light wave absorption through a probe placed on ones finger.
Question:
Arterial blood gas is an:
