NYC Master Electrician Exam (2026/2027) |
Newest Questions | 100% Correct Answers |
A+ Verified
• Where internal combustion engines are used as the prime motor, an on
site fuel supply shall be provided with an on premise fuel supply
sufficient for not less than ____ hours full demand operation of the
system -✓✓6 hours
• Fixed in place X-ray equipment properly supplied by a branch circuit
rated at not over ____ amperes shall be permitted to be supplied through
a suitable attachment plug cap and hard service cable cord. -✓✓30
Amps
• Where skin effect exist the ferromagnetic envelope shall be bonded at
____. -✓✓Both ends
• GFCI protection at a carnival is not required for equipment at circuit if
the receptacle is of the ____type. -✓✓Locking
• The maximum voltage drop from service point to the last over-current
device in a dwelling unit? -✓✓4%
• Which of the following statements best describe the grounding
requirement for central vacuum outlet -✓✓Accessible non current
carrying metal parts are required to be connected to an equipment
grounding conductor.
,• In healthcare facilities, patient bed receptacles located in general care
areas shall be supplied by at least two branch circuits, which
____permitted to originate from two separate transfer switches on the
emergency system -✓✓Are permitted
• Patient care areas of healthcare facilities ____ areas such as business
offices, corridors, lounges ,day rooms, or similar areas -✓✓Do not
include
• The patient care area is any portion of the healthcare facility where
patients are intended to be ____or ____. -✓✓Examined or treated
• Each general care area patient bed location in a healthcare facility must
be provided with four ____ or ____ duplex receptacles -✓✓Single or
two
• A hospital is a building or portion thereof used for medical,
psychiatric,obstetrical , or surgical, care on a 24 hour basis of ____ or
more patients -✓✓Four
• Where installed to reduce electrical noise for electronic equipment,
electrical continuity of the metal raceways shall not be required and
metal raceway can terminate a (an) ____ nonmetallic fitting or spacer on
electronic equipment -✓✓Listed fitting
,• Feeder and branch circuit conductors within ____ inches of a Ballast
shall have an insulation temperature rating not lower than 90°C (194°F)
unless supplying a luminaiere marked as suitable for a different
insulation temperature -✓✓3 inches
• Manufactured wiring systems constructed with type MC cable shall be
supported and secured at intervals not exceeding ____ ft. -✓✓6 ft
• Where a main bonding jumper or a system bonding jumper is a screw
only the screw shall be identified with a ____ that shall be visible with
the screw installed -✓✓Green finish
• Plug fuses a 15 amperes and lower rating shall be identified by a ____
configuration of the window, cap, or other prominent part to distinguish
them from fuses of higher ampere rating -✓✓Hexagon
• The load for household electric clothes dryer's in a dwelling unit(s)
shall be either ____ watts (volt-amperes) or the nameplate rating, which
ever is larger, for each dryer served ? -✓✓5000 watts
• Service conductors installed as unjacketed multiconductor cable shall
have a minimum clearance of ____ windows that are designed to be
opened, doors, porches, stairs fire escape or similar locations. -✓✓3 ft
(36 inches)
, • —— Cartridge fuses of the renewable type shall be permitted to be
used only for replacement in existing installation is where there is no
evidence of over-fusing or tampering. -✓✓Class H
• Branch circuit conductors within ____inches of the ballast shall have
an insulation temperature rating not lower it 90°C 194°F -✓✓3" inches
• The minimum radius of a field bend on trade size 1 "1/4 RMC is ____.
-✓✓8
• In a dwelling unit which appliance is allowed to have a 24"inch cord
with Attachment ground plug ? -✓✓Combination range
hood/microwave oven
• Type 3 Surge Protective devices can be installed on the load side of a
branch circuit overcurrent device up to the equipment served.if ____ the
type 3 SPD connection must be a minimum 30'ft of conductor a distance
from the service or separately derived system disconnect -✓✓Included
in the manufactures instructions
• Which flexible cable is Allowed to be used for electric vehicle
charging station 300 Volts ? -✓✓EVJ
• Type ____ fuse adapters shall be designed so that once inserted in a
fuse holder that cannot be removed -✓✓Type S fuse
Newest Questions | 100% Correct Answers |
A+ Verified
• Where internal combustion engines are used as the prime motor, an on
site fuel supply shall be provided with an on premise fuel supply
sufficient for not less than ____ hours full demand operation of the
system -✓✓6 hours
• Fixed in place X-ray equipment properly supplied by a branch circuit
rated at not over ____ amperes shall be permitted to be supplied through
a suitable attachment plug cap and hard service cable cord. -✓✓30
Amps
• Where skin effect exist the ferromagnetic envelope shall be bonded at
____. -✓✓Both ends
• GFCI protection at a carnival is not required for equipment at circuit if
the receptacle is of the ____type. -✓✓Locking
• The maximum voltage drop from service point to the last over-current
device in a dwelling unit? -✓✓4%
• Which of the following statements best describe the grounding
requirement for central vacuum outlet -✓✓Accessible non current
carrying metal parts are required to be connected to an equipment
grounding conductor.
,• In healthcare facilities, patient bed receptacles located in general care
areas shall be supplied by at least two branch circuits, which
____permitted to originate from two separate transfer switches on the
emergency system -✓✓Are permitted
• Patient care areas of healthcare facilities ____ areas such as business
offices, corridors, lounges ,day rooms, or similar areas -✓✓Do not
include
• The patient care area is any portion of the healthcare facility where
patients are intended to be ____or ____. -✓✓Examined or treated
• Each general care area patient bed location in a healthcare facility must
be provided with four ____ or ____ duplex receptacles -✓✓Single or
two
• A hospital is a building or portion thereof used for medical,
psychiatric,obstetrical , or surgical, care on a 24 hour basis of ____ or
more patients -✓✓Four
• Where installed to reduce electrical noise for electronic equipment,
electrical continuity of the metal raceways shall not be required and
metal raceway can terminate a (an) ____ nonmetallic fitting or spacer on
electronic equipment -✓✓Listed fitting
,• Feeder and branch circuit conductors within ____ inches of a Ballast
shall have an insulation temperature rating not lower than 90°C (194°F)
unless supplying a luminaiere marked as suitable for a different
insulation temperature -✓✓3 inches
• Manufactured wiring systems constructed with type MC cable shall be
supported and secured at intervals not exceeding ____ ft. -✓✓6 ft
• Where a main bonding jumper or a system bonding jumper is a screw
only the screw shall be identified with a ____ that shall be visible with
the screw installed -✓✓Green finish
• Plug fuses a 15 amperes and lower rating shall be identified by a ____
configuration of the window, cap, or other prominent part to distinguish
them from fuses of higher ampere rating -✓✓Hexagon
• The load for household electric clothes dryer's in a dwelling unit(s)
shall be either ____ watts (volt-amperes) or the nameplate rating, which
ever is larger, for each dryer served ? -✓✓5000 watts
• Service conductors installed as unjacketed multiconductor cable shall
have a minimum clearance of ____ windows that are designed to be
opened, doors, porches, stairs fire escape or similar locations. -✓✓3 ft
(36 inches)
, • —— Cartridge fuses of the renewable type shall be permitted to be
used only for replacement in existing installation is where there is no
evidence of over-fusing or tampering. -✓✓Class H
• Branch circuit conductors within ____inches of the ballast shall have
an insulation temperature rating not lower it 90°C 194°F -✓✓3" inches
• The minimum radius of a field bend on trade size 1 "1/4 RMC is ____.
-✓✓8
• In a dwelling unit which appliance is allowed to have a 24"inch cord
with Attachment ground plug ? -✓✓Combination range
hood/microwave oven
• Type 3 Surge Protective devices can be installed on the load side of a
branch circuit overcurrent device up to the equipment served.if ____ the
type 3 SPD connection must be a minimum 30'ft of conductor a distance
from the service or separately derived system disconnect -✓✓Included
in the manufactures instructions
• Which flexible cable is Allowed to be used for electric vehicle
charging station 300 Volts ? -✓✓EVJ
• Type ____ fuse adapters shall be designed so that once inserted in a
fuse holder that cannot be removed -✓✓Type S fuse
