ETA LEJATC YEAR 1 QUIZ 3 REVIEW
UPDATED ACTUAL Questions and
CORRECT Answers
Grounding is normally a ? protective measure to protect against electric shock. It does not guarantee that
you won't get a shock or be injured or killed by an electrical current.
a.first
b.preliminary
c.primary
d.secondary - CORRECT ANSWER - D
If a space contains a material that has the potential for engulfing an entrant, it is considered a ? .
a.confined space
b.permit space - CORRECT ANSWER - B
A Journey-level worker is told to run a three-inch conduit across a room and decides to use a channel-iron
system. The apprentice suggests that one-hole straps might be quicker. What might happen?
a.The apprentice should try to convince the Journey-level worker to change his or her mind.
b.The Journey-level worker should explain the reasoning behind his or her decision. The apprentice
should respect and defer to the Journey-level worker's experience.
c.The matter should be brought to the attention of the foreman or contractor.
d.All of the above. - CORRECT ANSWER - B
Which type of "push around" type of lift is essentially used as a ladder replacement?
a.Aerial work platforms
b.Articulating booms
c.Boom lifts
d.Vertical mast lifts - CORRECT ANSWER - A
? is a keen sense of what to do or say in order to maintain good relations with others or avoid offense.
,a.Observation
b.Perception
c.Respect
d.Tact - CORRECT ANSWER - D
An entry supervisor also may serve as an attendant or as an authorized entrant, as long as that person is
trained and equipped as required by this standard for each role he or she fills.
Select one:
True
False - CORRECT ANSWER - A
A(n) ? is "one who is capable of identifying existing and predictable hazards in the surroundings or
working conditions which are unsanitary, hazardous, or dangerous to employees, and who has the
authority to take prompt corrective measures to eliminate them."
a.competent person
b.confined space person
c.entry employer
d.permit space entry controller - CORRECT ANSWER - A
Before getting down from a scaffold, you should always check to be sure that materials or tools ? .
a.are not left in a position from which they might fall if the scaffold is moved
b.are not left on a scaffold with toe boards if it is moved
c.are removed before you climb down from the scaffold
d.are tied to the hand guards before a scaffold is moved - CORRECT ANSWER - A
Which of the following would not be a factor that determines the severity of an electric shock?I. The
amount of current flowing through the bodyII. The current's frequencyIII. The current's path through the
bodyIV. The length of time the body remains in the circuit
a.II. is not a factor that determines the severity of an electric shock.
b.II. and IV. are not factors that determine the severity of an electric shock.
c.III. is not a factor that determines the severity of an electric shock.
,d.IV. is not a factor that determines the severity of an electric shock.
e.All are factors that determine the severity of an electric shock. - CORRECT ANSWER - E
Effective emergency planning is vital to ensure that any entrant who becomes sick or is injured in a
permit space can be evacuated quickly and safely. ? permit space program must therefore include
procedures for entrants to be rescued in a timely manner by qualified personnel.
a.All employers
b.The controlling contractor's
c.The entry employer's
d.The host employer's - CORRECT ANSWER - C
What dangers are associated with accumulated trash on a jobsite?
a.Accumulated trash conceals dangers that can cause injuries.
b.Accumulated trash is a fire hazard.
c.Accumulated trash makes tripping or falls possible.
d.All of the above - CORRECT ANSWER - D
The employer ? advise employees of the location of energized electric power circuits, the hazards
involved, and the protective measures to be taken.
a.may
b.shall
c.should
d.will - CORRECT ANSWER - B
What should be done with a ladder when it is not in use?
a.It should be laid down or lashed where it cannot fall or be blown over.
b.It should be removed from the jobsite at the end of each day.
c.It should be stood up and placed in a stairwell where there is less traffic.
d.It should be stood up in a passageway so no one will trip over it. - CORRECT ANSWER - A
, Planking shall have at least 12 inches of overlap and extend 6 inches beyond center of support, or ? at
both ends to prevent sliding off supports.
a.be cleated
b.be number 2 planking boards
c.horizontal cross braced
d.planking boards cannot be used - CORRECT ANSWER - A
Most electrical accidents result from ? .
a.unsafe environment
b.unsafe equipment or installation
c.unsafe work practices
d.all of the above - CORRECT ANSWER - D
Which of the following is considered an unsafe condition in the electrical trades?
a.Carrying too heavy of a load up a ladder
b.Placing an extension ladder at too great an angle
c.A metal ladder
d.Working off the top rung of a ladder - CORRECT ANSWER - C
Rolling scaffolds require ? and toeboards to be safe.
a.foot guards
b.guardrails
c.hand guards
d.safety nets - CORRECT ANSWER - B
ANSI defines "Familiarization" of MEWPs as: Instruction to enable the trainee to become a qualified
person regarding the task to be performed, including knowledge regarding potential hazards.
Select one:
True
False - CORRECT ANSWER - B
UPDATED ACTUAL Questions and
CORRECT Answers
Grounding is normally a ? protective measure to protect against electric shock. It does not guarantee that
you won't get a shock or be injured or killed by an electrical current.
a.first
b.preliminary
c.primary
d.secondary - CORRECT ANSWER - D
If a space contains a material that has the potential for engulfing an entrant, it is considered a ? .
a.confined space
b.permit space - CORRECT ANSWER - B
A Journey-level worker is told to run a three-inch conduit across a room and decides to use a channel-iron
system. The apprentice suggests that one-hole straps might be quicker. What might happen?
a.The apprentice should try to convince the Journey-level worker to change his or her mind.
b.The Journey-level worker should explain the reasoning behind his or her decision. The apprentice
should respect and defer to the Journey-level worker's experience.
c.The matter should be brought to the attention of the foreman or contractor.
d.All of the above. - CORRECT ANSWER - B
Which type of "push around" type of lift is essentially used as a ladder replacement?
a.Aerial work platforms
b.Articulating booms
c.Boom lifts
d.Vertical mast lifts - CORRECT ANSWER - A
? is a keen sense of what to do or say in order to maintain good relations with others or avoid offense.
,a.Observation
b.Perception
c.Respect
d.Tact - CORRECT ANSWER - D
An entry supervisor also may serve as an attendant or as an authorized entrant, as long as that person is
trained and equipped as required by this standard for each role he or she fills.
Select one:
True
False - CORRECT ANSWER - A
A(n) ? is "one who is capable of identifying existing and predictable hazards in the surroundings or
working conditions which are unsanitary, hazardous, or dangerous to employees, and who has the
authority to take prompt corrective measures to eliminate them."
a.competent person
b.confined space person
c.entry employer
d.permit space entry controller - CORRECT ANSWER - A
Before getting down from a scaffold, you should always check to be sure that materials or tools ? .
a.are not left in a position from which they might fall if the scaffold is moved
b.are not left on a scaffold with toe boards if it is moved
c.are removed before you climb down from the scaffold
d.are tied to the hand guards before a scaffold is moved - CORRECT ANSWER - A
Which of the following would not be a factor that determines the severity of an electric shock?I. The
amount of current flowing through the bodyII. The current's frequencyIII. The current's path through the
bodyIV. The length of time the body remains in the circuit
a.II. is not a factor that determines the severity of an electric shock.
b.II. and IV. are not factors that determine the severity of an electric shock.
c.III. is not a factor that determines the severity of an electric shock.
,d.IV. is not a factor that determines the severity of an electric shock.
e.All are factors that determine the severity of an electric shock. - CORRECT ANSWER - E
Effective emergency planning is vital to ensure that any entrant who becomes sick or is injured in a
permit space can be evacuated quickly and safely. ? permit space program must therefore include
procedures for entrants to be rescued in a timely manner by qualified personnel.
a.All employers
b.The controlling contractor's
c.The entry employer's
d.The host employer's - CORRECT ANSWER - C
What dangers are associated with accumulated trash on a jobsite?
a.Accumulated trash conceals dangers that can cause injuries.
b.Accumulated trash is a fire hazard.
c.Accumulated trash makes tripping or falls possible.
d.All of the above - CORRECT ANSWER - D
The employer ? advise employees of the location of energized electric power circuits, the hazards
involved, and the protective measures to be taken.
a.may
b.shall
c.should
d.will - CORRECT ANSWER - B
What should be done with a ladder when it is not in use?
a.It should be laid down or lashed where it cannot fall or be blown over.
b.It should be removed from the jobsite at the end of each day.
c.It should be stood up and placed in a stairwell where there is less traffic.
d.It should be stood up in a passageway so no one will trip over it. - CORRECT ANSWER - A
, Planking shall have at least 12 inches of overlap and extend 6 inches beyond center of support, or ? at
both ends to prevent sliding off supports.
a.be cleated
b.be number 2 planking boards
c.horizontal cross braced
d.planking boards cannot be used - CORRECT ANSWER - A
Most electrical accidents result from ? .
a.unsafe environment
b.unsafe equipment or installation
c.unsafe work practices
d.all of the above - CORRECT ANSWER - D
Which of the following is considered an unsafe condition in the electrical trades?
a.Carrying too heavy of a load up a ladder
b.Placing an extension ladder at too great an angle
c.A metal ladder
d.Working off the top rung of a ladder - CORRECT ANSWER - C
Rolling scaffolds require ? and toeboards to be safe.
a.foot guards
b.guardrails
c.hand guards
d.safety nets - CORRECT ANSWER - B
ANSI defines "Familiarization" of MEWPs as: Instruction to enable the trainee to become a qualified
person regarding the task to be performed, including knowledge regarding potential hazards.
Select one:
True
False - CORRECT ANSWER - B
