NIMS MMS FINAL PAPER 2026 COMPLETE
ANSWERS VERIFIED
◉ A reaming operation produces finish tears. What is the cause of
these tears. Answer: a reamer with a worn tip
◉ What is a gage block height for an angle of 17 degrees on a 5" sine
plat?. Answer: 1.4618
◉ Which of the following gage block combinations can be used to
find a gage length of .9528. Answer: .1008,.102,.750
◉ The process of displacing air between gage blocks for accurate
measurements is called. Answer: wringing
◉ To check the height of multiple parts with gage blocks a machinist
would use a:. Answer: dial indicator and digital height gage
vernier caliper and telescoping gage
◉ Surface finish is checked with:. Answer: Comparison chart
◉ What unit is surface finish measured in?. Answer: Micro inches
, ◉ What is the most common type of surface finish called?. Answer:
roughness
◉ A part is considered a reject when. Answer: dimensions are out of
tolerance
◉ A sampling is referred to as what?. Answer: samples taken from a
machine over a period of time
◉ Inspection plans are needed to:. Answer: Coordinate inspection
procedures, identifying measuring tools, check dimensions in a
repeatable and reliable way
◉ The first thing to do when constructing an inspection plan is to:.
Answer: select the critical and important dimensions to inspect
◉ The most important factor in selecting measuring tools for
inspection is. Answer: tolerancing of dimensions to inspect
◉ Sampling plans contribute to a quality control process by:.
Answer: providing an acceptable representation of all parts
produced
ANSWERS VERIFIED
◉ A reaming operation produces finish tears. What is the cause of
these tears. Answer: a reamer with a worn tip
◉ What is a gage block height for an angle of 17 degrees on a 5" sine
plat?. Answer: 1.4618
◉ Which of the following gage block combinations can be used to
find a gage length of .9528. Answer: .1008,.102,.750
◉ The process of displacing air between gage blocks for accurate
measurements is called. Answer: wringing
◉ To check the height of multiple parts with gage blocks a machinist
would use a:. Answer: dial indicator and digital height gage
vernier caliper and telescoping gage
◉ Surface finish is checked with:. Answer: Comparison chart
◉ What unit is surface finish measured in?. Answer: Micro inches
, ◉ What is the most common type of surface finish called?. Answer:
roughness
◉ A part is considered a reject when. Answer: dimensions are out of
tolerance
◉ A sampling is referred to as what?. Answer: samples taken from a
machine over a period of time
◉ Inspection plans are needed to:. Answer: Coordinate inspection
procedures, identifying measuring tools, check dimensions in a
repeatable and reliable way
◉ The first thing to do when constructing an inspection plan is to:.
Answer: select the critical and important dimensions to inspect
◉ The most important factor in selecting measuring tools for
inspection is. Answer: tolerancing of dimensions to inspect
◉ Sampling plans contribute to a quality control process by:.
Answer: providing an acceptable representation of all parts
produced
