MISSOURI BOATING LICENCE ACTUAL EXAM QUESTIONS
AND CORRECT DETAILED ANSWERS LATEST UPDATES
2026 (VERIFIED ANSWERS) ALREADY GRADED A+
Bow - ANSWERS-Front of the vessel.
Stern - ANSWERS-Rear of the vessel.
Starboard - ANSWERS-Right side of the vessel.
Port - ANSWERS-Left side of the vessel.
Hull - ANSWERS-Body of the vessel.
Gunwale - ANSWERS-Upper edge of vessel's side.
Cleat - ANSWERS-Metal fitting on which a rope can be fastened.
Propeller - ANSWERS-Rotates and powers a boat forward or backward.
Beam - ANSWERS-Maximum width of a vessel.
,Freeboard - ANSWERS-Distance from water to lowest point of the boat where water could come
on board.
Draft - ANSWERS-Depth of the water needed to float a vessel.
Keel - ANSWERS-Main centerline (backbone) of a vessel or the extension of hull that increases
stability in the water.
Hull - ANSWERS-Body of a vessel; basic structure or shell.
Personal watercraft - ANSWERS-A small vessel that uses an inboard jet drive as its primary
source of propulsion, and is designed to be operated by a person or persons sitting, standing, or
kneeling on the vessel rather than inside the vessel.
Displacement Mode - ANSWERS-A planing hull, when operated at very slow speeds, will cut
through the water like a displacement hull.
Plowing Mode - ANSWERS-As speed increases, a planing hull will have a raised bow, reducing
the operator's vision and throwing a very large wake. Avoid maintaining a speed that puts your
boat in plowing mode.
Planing Mode - ANSWERS-Your boat is in planing mode when enough power is applied so that
the hull glides on top of the water. Different boats reach planing mode at different speeds.
Bow - ANSWERS-Front of a vessel.
Length overall - ANSWERS-Length of the hull excluding any attachments.
,Rudder - ANSWERS-Steering device, usually a vertical blade attached to a post at, or near, the
stern of the boat.
Stern - ANSWERS-Rear of a vessel
Flat Bottom Hull Advantages - ANSWERS-This planing hull has a shallow draft, which is good for
fishing in small lakes and rivers.
Deep Vee Hull Advantages - ANSWERS-This planing hull gives a smoother ride than a flat bottom
hull in rough water.
Round Bottom Hull Advantages - ANSWERS-This typical displacement hull moves easily through
the water even at slow speeds.
Multi Hull Advantages - ANSWERS-Another example of a displacement hull, the multi-hull has
greater stability because of its wide beam.
Flat Bottom Hull Disadvantages - ANSWERS-Rides roughly and choppy in the waters.
Deep Vee Hull Disadvantages - ANSWERS-Takes more power to move at the same speed as flat
bottom hulls. May roll or bank in sharp turns.
Round Bottom Hull Disadvantages - ANSWERS-Has a tendency to roll unless it has a deep keel or
stabilizers.
Multi Hull Disadvantages - ANSWERS-Needs a large area when turning.
Class A - ANSWERS-Less than 16 feet.
, Class 1 - ANSWERS-16 feet less than 26 feet.
Class 2 - ANSWERS-26 feet less than 40 feet.
Class 3 - ANSWERS-40 feet to less than 65 feet.
Propeller - ANSWERS-Rotating device that turns and powers a boat forward or backward.
Tiller - ANSWERS-Lever used to turn a rudder to steer a boat.
Transform - ANSWERS-Vertical surface at the back of the hull.
Steering Control - ANSWERS-Means of controlling the steering nozzle.
Safety Lanyard - ANSWERS-Short cord for attaching the ignition safety switch to the operators
wrist or personal life vest.
Throttle - ANSWERS-Lever.
Starboard - ANSWERS-Right side.
Port - ANSWERS-Left side.
Fuel cap - ANSWERS-Where you put gas in on the left side of the seadoo.
AND CORRECT DETAILED ANSWERS LATEST UPDATES
2026 (VERIFIED ANSWERS) ALREADY GRADED A+
Bow - ANSWERS-Front of the vessel.
Stern - ANSWERS-Rear of the vessel.
Starboard - ANSWERS-Right side of the vessel.
Port - ANSWERS-Left side of the vessel.
Hull - ANSWERS-Body of the vessel.
Gunwale - ANSWERS-Upper edge of vessel's side.
Cleat - ANSWERS-Metal fitting on which a rope can be fastened.
Propeller - ANSWERS-Rotates and powers a boat forward or backward.
Beam - ANSWERS-Maximum width of a vessel.
,Freeboard - ANSWERS-Distance from water to lowest point of the boat where water could come
on board.
Draft - ANSWERS-Depth of the water needed to float a vessel.
Keel - ANSWERS-Main centerline (backbone) of a vessel or the extension of hull that increases
stability in the water.
Hull - ANSWERS-Body of a vessel; basic structure or shell.
Personal watercraft - ANSWERS-A small vessel that uses an inboard jet drive as its primary
source of propulsion, and is designed to be operated by a person or persons sitting, standing, or
kneeling on the vessel rather than inside the vessel.
Displacement Mode - ANSWERS-A planing hull, when operated at very slow speeds, will cut
through the water like a displacement hull.
Plowing Mode - ANSWERS-As speed increases, a planing hull will have a raised bow, reducing
the operator's vision and throwing a very large wake. Avoid maintaining a speed that puts your
boat in plowing mode.
Planing Mode - ANSWERS-Your boat is in planing mode when enough power is applied so that
the hull glides on top of the water. Different boats reach planing mode at different speeds.
Bow - ANSWERS-Front of a vessel.
Length overall - ANSWERS-Length of the hull excluding any attachments.
,Rudder - ANSWERS-Steering device, usually a vertical blade attached to a post at, or near, the
stern of the boat.
Stern - ANSWERS-Rear of a vessel
Flat Bottom Hull Advantages - ANSWERS-This planing hull has a shallow draft, which is good for
fishing in small lakes and rivers.
Deep Vee Hull Advantages - ANSWERS-This planing hull gives a smoother ride than a flat bottom
hull in rough water.
Round Bottom Hull Advantages - ANSWERS-This typical displacement hull moves easily through
the water even at slow speeds.
Multi Hull Advantages - ANSWERS-Another example of a displacement hull, the multi-hull has
greater stability because of its wide beam.
Flat Bottom Hull Disadvantages - ANSWERS-Rides roughly and choppy in the waters.
Deep Vee Hull Disadvantages - ANSWERS-Takes more power to move at the same speed as flat
bottom hulls. May roll or bank in sharp turns.
Round Bottom Hull Disadvantages - ANSWERS-Has a tendency to roll unless it has a deep keel or
stabilizers.
Multi Hull Disadvantages - ANSWERS-Needs a large area when turning.
Class A - ANSWERS-Less than 16 feet.
, Class 1 - ANSWERS-16 feet less than 26 feet.
Class 2 - ANSWERS-26 feet less than 40 feet.
Class 3 - ANSWERS-40 feet to less than 65 feet.
Propeller - ANSWERS-Rotating device that turns and powers a boat forward or backward.
Tiller - ANSWERS-Lever used to turn a rudder to steer a boat.
Transform - ANSWERS-Vertical surface at the back of the hull.
Steering Control - ANSWERS-Means of controlling the steering nozzle.
Safety Lanyard - ANSWERS-Short cord for attaching the ignition safety switch to the operators
wrist or personal life vest.
Throttle - ANSWERS-Lever.
Starboard - ANSWERS-Right side.
Port - ANSWERS-Left side.
Fuel cap - ANSWERS-Where you put gas in on the left side of the seadoo.
