PIPEFITTER STAR CERTIFICATION REVIEW
SET 2026 ANSWERS GUARANTEED PASS
⫸ Fall hazards, Electrical hazards, Caught in, Struck by Answer: Four
focus inspectioin OSHA compliance officers look for:
⫸ Plane End Square Cut (PESC)
Thread and Coupling (T&C)
Thread Both Ends (TBE) Answer: Steel pipe is supplied with the
following end finish:
⫸ Start/Stop, Regulate/Throttle, Relief, Reduce Answer: Four principle
functions of valves
⫸ 125F Answer: Never expose any part of a compressed gas cylinder to
temperatures above:
⫸ 350F Answer: Max service temperature of a brazed joint?
⫸ Straight, Choker, Basket Answer: Three basic hitches which can be
used for lifting with a sling
,⫸ 6300F Answer: Oxyacetylene flame has a peak temperature of
roughly:
⫸ Immediate danger to Live and Health Answer: IDLH in regards to
OSHA stands for
⫸ Inhalation, ingestion, absorption, and injection. Answer: Four routes
of entry into the human body are
⫸ Are impelled along a conductor Answer: When voltage is applied
along a conductor, free electrons:
⫸ Exists at all points along it's length Answer: The magnetic field
around a current carrying wire:
⫸ Voltage/Amps Answer: What is the formula for electrical resistance
(ohms)
⫸ Thermocouple Answer: A ________ generates a small amount of
voltage when heated.
⫸ Sensible heat Answer: The quantity of heat involved to change a
substance that can be measured with a thermometer.
⫸ Latent heat Answer: The amount of heat required to bring about a
change in state in a substance.
, ⫸ Specific heat Answer: The amount of heat in BTU's required to
change the temperature of 1 lb of a substance 1 degree F
⫸ force per unit of area Answer: Pressure is ___________ per
_________ _______
⫸ Positive diplacement and Non-positive displacement pumps. Answer:
Name the two main classifications of pump types
⫸ Parallel and Angular alignment Answer: What are two kinds of
misalignment that must be checked for when installing pumps?
⫸ Prime, check suction and discharge valves, check rototion Answer:
What steps should be taken before starting a pump for the first time?
⫸ Head in Feet and GPM Answer: What are two of the three main items
shown on a pump curve?
⫸ 34 Answer: Theoretically, how many feet can a pump raise water
vertically by suction?
⫸ Float and electric probe type
*must have two, one may be probe. Answer: The two basic types of low-
water cutoff's are:
SET 2026 ANSWERS GUARANTEED PASS
⫸ Fall hazards, Electrical hazards, Caught in, Struck by Answer: Four
focus inspectioin OSHA compliance officers look for:
⫸ Plane End Square Cut (PESC)
Thread and Coupling (T&C)
Thread Both Ends (TBE) Answer: Steel pipe is supplied with the
following end finish:
⫸ Start/Stop, Regulate/Throttle, Relief, Reduce Answer: Four principle
functions of valves
⫸ 125F Answer: Never expose any part of a compressed gas cylinder to
temperatures above:
⫸ 350F Answer: Max service temperature of a brazed joint?
⫸ Straight, Choker, Basket Answer: Three basic hitches which can be
used for lifting with a sling
,⫸ 6300F Answer: Oxyacetylene flame has a peak temperature of
roughly:
⫸ Immediate danger to Live and Health Answer: IDLH in regards to
OSHA stands for
⫸ Inhalation, ingestion, absorption, and injection. Answer: Four routes
of entry into the human body are
⫸ Are impelled along a conductor Answer: When voltage is applied
along a conductor, free electrons:
⫸ Exists at all points along it's length Answer: The magnetic field
around a current carrying wire:
⫸ Voltage/Amps Answer: What is the formula for electrical resistance
(ohms)
⫸ Thermocouple Answer: A ________ generates a small amount of
voltage when heated.
⫸ Sensible heat Answer: The quantity of heat involved to change a
substance that can be measured with a thermometer.
⫸ Latent heat Answer: The amount of heat required to bring about a
change in state in a substance.
, ⫸ Specific heat Answer: The amount of heat in BTU's required to
change the temperature of 1 lb of a substance 1 degree F
⫸ force per unit of area Answer: Pressure is ___________ per
_________ _______
⫸ Positive diplacement and Non-positive displacement pumps. Answer:
Name the two main classifications of pump types
⫸ Parallel and Angular alignment Answer: What are two kinds of
misalignment that must be checked for when installing pumps?
⫸ Prime, check suction and discharge valves, check rototion Answer:
What steps should be taken before starting a pump for the first time?
⫸ Head in Feet and GPM Answer: What are two of the three main items
shown on a pump curve?
⫸ 34 Answer: Theoretically, how many feet can a pump raise water
vertically by suction?
⫸ Float and electric probe type
*must have two, one may be probe. Answer: The two basic types of low-
water cutoff's are:
