RVTI Level 2 Technician Certification Exam Practice Questions And Correct Answers (100% Solved) Latest Update | Graded A+ | Guaranteed Pass.

RVTI Level 2 Technician Certification Exam Practice Questions And Correct Answers (100% Solved) Latest Update | Graded A+ | Guaranteed Pass. 1. Which of the following best describes the main function of an RVTI Level 2 technician? A. Design new testing protocols B. Perform basic inspections only C. Conduct advanced vehicle testing and troubleshooting D. Oversee administrative operations This is correct because Level 2 technicians are responsible for advanced testing and troubleshooting, not just basic inspections or administrative tasks. 2. When conducting a diagnostic test on a vehicle system, the first step is to: A. Replace faulty components immediately B. Review vehicle history and perform preliminary inspections C. Notify the client of potential costs D. Update software without testing Reviewing history and performing inspections ensures diagnostics are accurate and targeted. 3. A vehicle fails emissions testing due to high CO levels. The technician should: A. Ignore it if the engine seems fine B. Check fuel system, ignition system, and air intake for faults C. Just adjust the sensors D. Report it as unfixable High CO can indicate incomplete combustion; checking related systems is necessary. 4. Which tool is essential for measuring vehicle electrical circuit resistance? A. Torque wrench B. Multimeter C. Vacuum gauge D. Flow meter A multimeter is used to measure voltage, current, and resistance in circuits. 5. Which of the following is the correct procedure for testing a vehicle’s cooling system? A. Only check the radiator cap B. Pressure test the system and inspect for leaks C. Drain the system completely D. Replace the thermostat without testing Pressure testing reveals leaks and ensures system integrity. 6. If a Level 2 technician identifies a misfire in a cylinder, the first diagnostic step is: A. Replace all spark plugs B. Check ignition coil and spark plug of the affected cylinder C. Replace the fuel injector D. Adjust the timing belt Targeted diagnostics prevent unnecessary replacements and pinpoint the problem. 7. The main function of a vehicle’s ECU (Engine Control Unit) is to: A. Control tire pressure B. Manage engine performance and emissions C. Regulate seatbelt tension D. Monitor oil levels only The ECU controls key engine functions, including fuel injection and emissions. 8. When performing a battery load test, the technician should: A. Only check the voltage without load B. Apply a load and measure voltage drop C. Jump-start the battery immediately D. Disconnect the alternator first Load testing shows whether a battery can sustain voltage under real-world conditions. 9. Which of the following indicates a leaking head gasket? A. Excessive tire wear B. Low brake fluid C. White smoke from exhaust and coolant in oil D. Malfunctioning ABS Coolant mixing with oil or exhaust smoke indicates head gasket failure. 10. For Level 2 technicians, the correct method to verify a fuel pump’s operation is: A. Shake the fuel tank B. Measure fuel pressure at the rail with a gauge C. Replace the pump regardless of symptoms D. Tap the pump lightly Fuel pressure measurement provides accurate pump performance data. 11. A technician should record all diagnostic steps because: A. It is required for billing B. It ensures repeatability and compliance with standards C. Clients demand paperwork D. It prevents theft of tools Documentation ensures accountability and consistency in diagnostics.